Key facts
- Brand
- D-Link
- Model
- DVG-6004S
- Category
- Communications equipment
- Documents
- 2
- Languages
- EN
- Last added
- 2023-11-24
Start here

D-Link DVG-6004S/6008S VoIP Gateway User Manual
This manual introduces the DVG-6004S/6008S VoIP Gateway, describing its hardware layout, front and rear panels, and the functions of its WAN, LAN, and FXO ports. It explains how to connect the gateway to a network and telephone lines, and outlines the supported voice codecs and SIP features.
The document then guides users through web‑based configuration, IVR setup, dialing principles, and advanced options such as NAT, DDNS, QoS, and firewall protection. An appendix lists detailed product features, call functions, and maintenance procedures.
D-Link DVG-6004S specifications
| Input power | 100-240 V, 50-60 Hz |
|---|---|
| Output power | 12 VDC |
| SIP protocol | SIP V2.0 |
| Voice codecs | G.711A/U law, G.723.1, G.729AB |
| Fax support | T.38/Pass-through |
| DTMF modes | Signal/RFC2833/INBAND |
| Echo cancellation | G.168 |
Source: D-Link DVG-6004S/DVG-6008S FXO Voice Gateway User Manual
All D-Link DVG-6004S documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What are the default web and telnet login credentials?
The default web and telnet username and password are both admin.
From: D-Link DVG-6004S/DVG-6008S FXO Voice Gateway User Manual
How do you make a direct IP call?
Pick up the analog phone, dial *47, enter the target IP address using * between octets, then press # or wait 3 seconds.
From: D-Link DVG-6004S/DVG-6008S FXO Voice Gateway User Manual
How do I reset the DVG-6004S/6008S to factory defaults?
Disconnect the power plug, press and hold the reset button for 6 seconds, reconnect power while holding the button, then release after 6 seconds.
What voice codecs are supported by the gateway?
The gateway supports G.711 a/ulaw, G.726, G.729A, and G.723.1 codecs.
