Key facts
- Brand
- Siemens
- Model
- 6EP1333-2AA01
- Industry
- Industrial
- Documents
- 2
- Languages
- EN · ZH
- Last added
- 2012-05-07
Start here
SIEMENS 6EP1332-2BA10 6EP1333-2BA01 6EP1334-2BA01 6EP1334-2AA01-0AA0 6EP1333-2AA01 6EP1334-2AA01 handbook
This manual contains important safety information for the SITOP Smart 24 V power supplies. Only qualified personnel may work on the equipment, the main switch must be turned off and locked out before any installation or maintenance, and a protective device (fuse) and disconnecting device must be provided. The units must be mounted vertically with a minimum 50 mm clearance above and below, and the input and output terminals must face downward.
The document also lists the electrical characteristics of the supplies: input voltage 120/230 V AC, input voltage range 85‑132 V / 170‑264 V AC, frequency 47‑63 Hz, output voltage 24 V DC, ripple <150/240 mV, efficiency up to 91 % at full load, protection class I, IP 20, operating temperature 0 °C‑+60 °C and storage temperature –40 °C‑+85 °C. Parallel operation of two identical units is allowed under specific conditions.
Siemens 6EP1333-2AA01 specifications
| Input nominal voltage | 120/230 V AC |
|---|---|
| Input voltage range | 85‑132 V / 170‑264 V AC |
| Input frequency range | 47‑63 Hz |
| Output nominal voltage | 24 V DC |
| Output ripple / spikes | < 150/240 mV |
| Protection class | I |
| IP rating | IP 20 |
| Operating temperature range | 0 °C … +60 °C |
| Storage temperature range | -40 °C … +85 °C |
All Siemens 6EP1333-2AA01 documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What safety steps must be taken before installing or servicing the SITOP power supply?
The main switch must be turned off and locked out, only qualified personnel may work on the equipment, and a protective device (fuse) and a disconnecting device must be provided.
How should the SITOP unit be mounted for proper cooling?
The device must be installed vertically with the input and output terminals at the bottom and a minimum free space of 50 mm above and below the unit.
What safety precautions must be taken before installing the SITOP Smart power supply?
Only qualified personnel should install or service the unit, power must be disconnected, and DIN 7437, IEC60364, and EN 50178 guidelines must be followed.
What is the required input voltage for the SITOP Smart series?
The power supplies accept an AC input voltage of 120 V to 230 V at 50 Hz or 60 Hz.