Key facts
Start here
Linksys PAP2T 2-Port Voice-over-IP Internet Phone Adapter User Guide
The Linksys PAP2T is a 2‑port Voice‑over‑IP Internet Phone Adapter that lets you make phone or fax calls over your broadband connection. It provides two independent telephone jacks, each able to support a separate Internet phone service.
This guide covers the hardware layout, step‑by‑step installation, configuration via the Interactive Voice Response menu, technical specifications, troubleshooting tips, warranty, regulatory information, and contact details for support.
Linksys PAP2T specifications
| Number of FXS ports | 2 |
|---|---|
| Ethernet port | 1 |
| Power input | 5‑volt DC adapter |
Source: Linksys PAP2T ATA User Guide
All Linksys PAP2T documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
How do I activate Caller ID for a call?
Lift the receiver, listen for a dial tone, then press *82 before dialing the number.
How can I temporarily disable Call Waiting?
Lift the receiver, listen for a dial tone, and press *70; Call Waiting will be disabled for that call.
How do I reset the PAP2?
Lift the handset, press the configuration key, then enter 73738# and press 1 to confirm; the device will reset.
How can I find the PAP2's IP address?
Lift the handset, press the star key four times to open the configuration menu, then press 110#; the device will announce its IP address.
What does the Power LED indicate?
The Power LED turns green when the adapter is powered on and connected to the Internet, and flashes when it is not connected or during boot/firmware upgrade.
From: Linksys PAP2T 2-Port Voice-over-IP Internet Phone Adapter User Guide
What cables are required to set up the PAP2T?
You need a power adapter, an Ethernet cable for the INTERNET port, and RJ‑11 telephone cables for each PHONE port.
From: Linksys PAP2T 2-Port Voice-over-IP Internet Phone Adapter User Guide