Key facts
- Brand
- Linear Technology
- Model
- TIA/EIA-232-F
- Category
- Communications equipment
- Industry
- Electronics
- Documents
- 2
- Languages
- EN
- Last added
- 2026-11-16
Start here

Linear Technology TIA/EIA-232-F RS232 Quick Guide
The RS232 Quick Guide from Linear Technology summarizes the TIA/EIA-232-F standard. It describes RS232 as a single-ended, point-to-point modem interface that conveys data over a simple unterminated multiconductor cable; the guide notes that later renderings removed unneeded signals to expand its use as a general purpose serial interface at data rates up to 1MB.
The guide provides a DB25/DB9 signal pinout, connector and cable wiring for straight-through, null modem and AT-to-25-pin adapter setups, and relative signal timing for communications. Its specification table lists a 50-foot maximum cable length, 20kB/s maximum data rate, ±25V driver output and receiver input limits, and 3k to 7k termination.
Linear Technology TIA/EIA-232-F specifications
| Mode of Operation | Single-ended |
|---|---|
| Drivers and Receivers per Line | 1 driver, 1 receiver |
| Maximum Cable Length | 50 feet* |
| Maximum Data Rate | 20kB/s |
| Maximum Voltage Applied to Driver Output | ±25V |
| Driver Output Signal | Minimum loaded ±5V; maximum unloaded ±15V |
| Termination | 3k < to 7k< |
| Receiver Input Sensitivity | ±3V |
All Linear Technology TIA/EIA-232-F documents by type
Questions answered in these manuals
What is the maximum cable length for RS232?
The guide lists a maximum cable length of 50 feet, with a footnote for 2500pF cable capacitance at data rates less than 20k baud.
What is the maximum data rate listed for RS232?
The specification table lists a maximum data rate of 20kB/s, and the guide says later renderings expanded use to data rates up to 1MB.
What is the maximum data rate for general purpose RS232?
The standard supports data rates up to 1MB/s for general use, though the original specification was intended for modems at up to 20kB/s.
From: Linear Technology RS232 Quick Guide TIA/EIA-232-F Standard
What are the maximum voltage limits for RS232 driver output?
The maximum voltage applied to the driver output is +/- 25V.
From: Linear Technology RS232 Quick Guide TIA/EIA-232-F Standard
