Linear Technology LTM9003 Manuals

ManualLib has 2 documents for the Linear Technology LTM9003 (electronic components): 1 application note, 1 product leaflet. Every file can be read online or downloaded as a PDF for free.

Application Note 1Product Leaflet 1

Key facts

Model
LTM9003
Documents
2
Languages
EN
Last added
2012-06-05

Start here

linear DESIGN FEATURES LTJournal-V20N2-07-di-LTM9003-Todd_Nelson service manual

linear DESIGN FEATURES LTJournal-V20N2-07-di-LTM9003-Todd_Nelson service manual

Application Note 3 pages · 770 KB · EN

The paper discusses the challenges of designing feedback receivers for Digital Predistortion (DPD) systems used to improve Power Amplifier (PA) efficiency. It highlights that while DPD algorithms are critical, the analog receiver design is equally demanding due to requirements for high linearity and wide bandwidth.

To address these challenges, Linear Technology introduces the LTM9003 pModule receiver. This fully integrated device combines a high-linearity active mixer, an IF amplifier, an LC bandpass filter, and a high-speed ADC into a single 11.25mm x 15mm package. The document details its performance characteristics, including low noise figure and excellent passband flatness, demonstrating how it simplifies board layout and reduces engineering time.

Read online

Linear Technology LTM9003 specifications

Package Dimensions11.25mm x 15mm
Supply Voltage3.3V and 2.5V
Power Consumptionabout 1.5W
ADC Sample Rate245.76MHz
Intermediate Frequency (IF)184.32MHz

Source: linear DESIGN FEATURES LTJournal-V20N2-07-di-LTM9003-Todd_Nelson service manual

All Linear Technology LTM9003 documents by type

Application Note 1

How to use the product for one specific task, with worked examples.

Questions answered in these manuals

How does the LTM9003 improve PA efficiency?

It enables digital predistortion by providing accurate RF feedback to reduce crest factor and allow the power amplifier to run closer to saturation.

From: linear DESIGN FEATURES LTJournal-V20N2-07-di-LTM9003-Todd_Nelson service manual

What is the required circuit board area for the LTM9003?

The device requires a circuit board area of only 11.25mm x 15mm.

From: linear DESIGN FEATURES LTJournal-V20N2-07-di-LTM9003-Todd_Nelson service manual

What is the LTM9003?

It is a wideband RF-to-digital receiver subsystem containing a 12-bit, 250Msps ADC, a bandpass filter, an IF amplifier and a high linearity RF downconverting mixer.

From: LINEAR 2PB_9003 Digital Predistortion Solutions

Which Xilinx devices does DPD V3.0 support?

The DPD V3.0 LogiCORE IP supports Xilinx Virtex-5, Virtex-6 and Spartan-6 devices.

From: LINEAR 2PB_9003 Digital Predistortion Solutions