Key facts
- Brand
- NEC
- Model
- HT410
- Category
- Other Electronics
- Documents
- 4
- Languages
- SV · ES · IT
- Last added
- 2012-05-10
Start here
NEC HT510/HT410 User Manual
This manual covers important safety information, proper installation, and connection guidelines for the NEC HT510/HT410 home cinema projector. It explains how to set up the unit on a flat, dry surface, keep adequate ventilation, and avoid direct sunlight or moisture.
The guide also details basic operation, menu functions, lamp replacement, service indicators, troubleshooting, and technical specifications such as power requirements, noise level, and native resolution. An appendix describes the optional TravelCare service program. This manual is written in Swedish.
NEC HT410 specifications
| Power Supply | 100‑240 V AC, 50/60 Hz |
|---|---|
| Noise Level (Eco mode) | 26 dB |
| Native Resolution (HT510) | 1024 × 576 |
| Native Resolution (HT410) | 854 × 480 |
Source: NEC HT510/HT410 User Manual
All NEC HT410 documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
How do I replace the lamp in the NEC HT510/HT410?
When the lamp‑life warning appears, wait at least 60 seconds after powering off, turn off the main switch, unplug the power cord, let the projector cool for 10 minutes, then replace the lamp as described on page W‑45.
What safety precautions should I observe before using the projector?
Read the manual carefully, keep the unit away from water, do not open the case, and disconnect the power plug before any service.
What power source does the projector require?
It must be connected to a 100‑240 V AC supply at 50 Hz or 60 Hz.
How do I replace the lamp?
Follow the lamp‑replacement instructions on the indicated page; the manual details the steps and safety precautions.
How should I power off the projector safely?
Turn off the main power, wait at least 10 minutes for the fan to stop, then disconnect the power cord.
How do I replace the lamp?
When the on‑screen message indicates the lamp has reached end‑of‑life, wait for the projector to cool, then follow the lamp‑replacement instructions on the indicated page.