Key facts
- Brand
- STMicroelectronics
- Model
- STP16DPPS05
- Documents
- 2
- Languages
- EN
- Last added
- 2012-08-10
Start here

ST STP16DPPS05 16-bit Constant Current LED Sink Driver Datasheet
The STP16DPPS05 is a monolithic, low-voltage 16-bit shift register designed for LED panel displays. It has a 16-bit serial-in, parallel-out shift register feeding a 16-bit D-type storage register, and sixteen regulated current sources provide 3 to 40 mA of constant current to drive LEDs.
The device includes open and short LED detection on the outputs for short to GND, short to VO, and open line conditions; the detection results are loaded in the shift registers and shifted out through the serial line output. It also provides auto power-saving and allows output current adjustment through an external resistor.
STMicroelectronics STP16DPPS05 specifications
| Supply voltage (recommended) | 3.0 to 5.5 V |
|---|---|
| Output channels | 16 constant current outputs |
| Output current | 3 to 40 mA |
| Clock frequency | 30 MHz |
| Output voltage | 20 V |
| ESD protection | 2 kV HBM, 200 V MM |
| Packages | SO-24, TSSOP24, TSSOP24 exposed pad, QSOP-24 |
| Operating free-air temperature range | -40 to +125 °C |
Source: ST STP16DPPS05 16-bit Constant Current LED Sink Driver Datasheet
All STMicroelectronics STP16DPPS05 documents by type
Ratings, dimensions and ordering codes, for selection and design work.
How to use the product for one specific task, with worked examples.
- ST AN3090 handbook 19 p
Questions answered in these manuals
What is the supply voltage range of the STP16DPPS05?
The recommended operating supply voltage is 3.0 V to 5.5 V.
From: ST STP16DPPS05 16-bit Constant Current LED Sink Driver Datasheet
How many LED output channels does it provide?
It provides 16 constant current output channels.
From: ST STP16DPPS05 16-bit Constant Current LED Sink Driver Datasheet
What is the maximum constant current this LED driver can provide?
The device provides a regulated constant current ranging from 3 to 40 mA.
From: ST AN3090 handbook
How long must the OE/DM2 signal stay low before checking for LED errors?
The acquisition time necessary to allow for correct LED feedback is typically 1 us.
From: ST AN3090 handbook
