Key facts
- Brand
- DELL
- Model
- 28xx
- Category
- Network Switches
- Documents
- 4
- Languages
- EN
- Last added
- 2026-11-10
Start here

Dell PowerConnect 28xx Switch Getting Started Guide
This Dell PowerConnect 28xx Systems Getting Started Guide provides basic information to install and start running the PowerConnect 2800 series of Web-managed Gigabit Ethernet switches, including models 2808, 2816, 2824, and 2848. The switches connect workstations and other network devices such as servers, hubs, and routers, and are intended for small office/home office and small to medium business environments.
The guide covers site preparation, unpacking, rack or wall mounting, connecting the device to the network, and initial configuration in managed or unmanaged mode. It also describes web configuration, the Green Ethernet feature, and regulatory notices.
Dell 28xx specifications
| Input voltage | 220/110 VAC |
|---|---|
| Input frequency | 50/60 Hz |
| Operating temperature | 0 to 45 °C (32 to 113 °F) |
| Relative humidity | up to 95%, non-condensing |
All Dell 28xx documents by type
The shortest path to a working setup, usually only a few pages.
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What mounting options are available for the device?
The device can be installed in a rack, on a flat surface, or on a wall.
What is the default management mode of the switch?
The switch is delivered from the factory in Unmanaged Mode.
What are the mounting options for the PowerConnect 2800 series?
The devices can be mounted in a standard equipment rack, placed on a tabletop, or mounted on the wall.
Is configuration required to use the switch as an unmanaged switch?
No, the switch is delivered from the factory in Unmanaged Mode and can be used simply by plugging it in.
What are the supported models in the PowerConnect 2800 series?
The supported models are PowerConnect 2808, 2816, 2824, and 2848.
Can the switch be used without configuration?
Yes, the switch is delivered from the factory in Unmanaged Mode and can be used simply by plugging it in.
