Dell PowerVault MD3000i Manuals

ManualLib has 7 documents for the Dell PowerVault MD3000i (Storage): 1 service manual, 2 installation guides, 1 other. Every file can be read online or downloaded as a PDF for free.

Service Manual 1Installation Guide 2Other 1

Key facts

Brand
DELL
Model
PowerVault MD3000i
Category
Storage
Documents
7
Languages
EN
Last added
2023-11-26

Start here

Dell PowerVault MD3000i Storage Array Single-Controller RAID Controller Module Replacement Service Manual

Dell PowerVault MD3000i Storage Array Single-Controller RAID Controller Module Replacement Service Manual

Service Manual 4 pages · 224 KB · EN

The document is a Dell service procedure for replacing a failed RAID controller module in a single-controller PowerVault MD3000i. It lists the removal steps: power down the enclosure, disconnect all cables, push up the release tab, pull the release lever, and remove the module. It also describes installing the replacement module until it is firmly seated in the backplane connector and the release lever is pushed in.

After replacement, the document explains updating RAID controller and NVSRAM firmware with the Single Controller Replacement Utility. This update is required only if the single-controller storage array enters lockdown mode after the replacement. The utility must be run from a computer with access to the storage array management port, and the RAID enclosure must contain at least two disk drives; on Windows run simplex.bat, and on Linux run simplex.sh.

Read online

Dell PowerVault MD3000i specifications

Supported configurationsDuplex (dual-controller) and simplex (single-controller)
Second RAID controller slotSlot 1
Expansion enclosures shown2

Source: Dell PowerVault MD3000i RAID Storage Array Simplex to Duplex Upgrade Guide

All Dell PowerVault MD3000i documents by type

Service Manual 1

Disassembly, diagnostics and part numbers, for repair.

Installation Guide 2

Mounting, wiring and first power-up. Read it before the hardware goes in.

Questions answered in these manuals

How do you remove a RAID controller module from a single-controller MD3000i?

Power down the enclosure, disconnect all cables, push up on the release tab, pull out the release lever, and remove the module. The document warns not to stack or place the module on a hard surface because of the EMI contacts.

From: Dell PowerVault MD3000i Storage Array Single-Controller RAID Controller Module Replacement Service Manual

When is the Single Controller Replacement Utility required?

It is required only if a single-controller storage array enters lockdown mode after replacement of a failed controller. The utility will not update a RAID controller that is not in lockdown mode.

From: Dell PowerVault MD3000i Storage Array Single-Controller RAID Controller Module Replacement Service Manual

Can a PowerVault MD3000i be upgraded from simplex to duplex without taking the storage array offline?

Yes. The document describes upgrading the array from simplex to duplex without taking the existing storage array offline.

From: Dell PowerVault MD3000i RAID Storage Array Simplex to Duplex Upgrade Guide

Which SMcli command changes the array mode from simplex to duplex?

The command is SMcli IP_address -c “set storageArray redundancyMode=duplex;”.

From: Dell PowerVault MD3000i RAID Storage Array Simplex to Duplex Upgrade Guide

Can the MD3000i be upgraded from simplex to duplex without taking the storage array offline?

Yes. The document describes steps to upgrade the storage array from a simplex configuration to a duplex configuration without taking the existing storage array offline.

From: Dell PowerVault MD3000i Upgrade Guide: Simplex to Duplex Mode

What redundancy does a duplex configuration provide?

A duplex configuration allows for full redundancy between RAID controller modules, non-I/O components, virtual disk paths, and physical disk paths.

From: Dell PowerVault MD3000i Upgrade Guide: Simplex to Duplex Mode