Dell PowerVault MD3000i Storage Array Single-Controller RAID Controller Module Replacement Service Manual

This document describes how to replace a failed RAID controller module in a single-controller MD3000i.


Dell PowerVault MD3000i Storage Array Single-Controller RAID Controller Module Replacement Service Manual - cover page
Brand
DELL
Category
Storage
Document type
Service Manual
Language
English
Pages
4
File format
PDF
File size
224 KB
Published
26 November, 2023
Updated
26 November, 2023
MD5 checksum
17E8374B429FB020631414A290E37ED0

About this manual

The document is a Dell service procedure for replacing a failed RAID controller module in a single-controller PowerVault MD3000i. It lists the removal steps: power down the enclosure, disconnect all cables, push up the release tab, pull the release lever, and remove the module. It also describes installing the replacement module until it is firmly seated in the backplane connector and the release lever is pushed in.

After replacement, the document explains updating RAID controller and NVSRAM firmware with the Single Controller Replacement Utility. This update is required only if the single-controller storage array enters lockdown mode after the replacement. The utility must be run from a computer with access to the storage array management port, and the RAID enclosure must contain at least two disk drives; on Windows run simplex.bat, and on Linux run simplex.sh.

What's inside

  • Replacing the RAID Controller Module
  • Removing the RAID Controller Module
  • Installing a Replacement RAID Controller Module
  • Updating RAID Controller and NVSRAM Firmware on the Replacement RAID Controller Module
  • Using the Single Controller Replacement Utility

Specifications

Controller configurationSingle-controller
Minimum disk drives for firmware updateAt least two

Frequently asked questions

How do you remove a RAID controller module from a single-controller MD3000i?

Power down the enclosure, disconnect all cables, push up on the release tab, pull out the release lever, and remove the module. The document warns not to stack or place the module on a hard surface because of the EMI contacts.

When is the Single Controller Replacement Utility required?

It is required only if a single-controller storage array enters lockdown mode after replacement of a failed controller. The utility will not update a RAID controller that is not in lockdown mode.

What is required to update the replacement controller firmware?

You need a server, workstation, or laptop with access to the management port and the Single Controller Replacement Utility. The RAID enclosure must contain at least two disk drives.

How do you run the Single Controller Replacement Utility on Windows or Linux?

After extracting the utility files, run simplex.bat on a Windows system or execute simplex.sh on a Linux system. A GUI-based wizard guides the remaining update steps.

Download PDF (224 KB)

More DELL Manuals


View all DELL manuals →