Intel USB4 Evaluation Dock Manuals

ManualLib has 2 documents for the Intel USB4 Evaluation Dock (Board): 2 user manuals. Every file can be read online or downloaded as a PDF for free.

User Manual 2

Key facts

Brand
Intel
Model
USB4 Evaluation Dock
Category
Board
Industry
Electronics
Documents
2
Languages
EN
Last added
2026-11-17

Start here

Intel USB4 Evaluation Dock Firmware Update Manual

Intel USB4 Evaluation Dock Firmware Update Manual

User Manual 32 pages · 3.4 MB · EN

This Intel manual describes how to update firmware on the Intel USB4 Evaluation Dock, covering the components Goshen Ridge (U8 – GR NVM), Delta Bridge (UB10 – DB NVM), USB2.0 Hub (UB6 – USB2 HUB NVM), Cypress DMC (J5) and Cypress CCG5 (J4). It lists the required equipment: a Dediprog SF600 SPI NOR Flash Programmer with an ISP-TC-8 (SO8) test clip, a Cypress MiniProg4 Program and Debug Kit CY8CKIT-005, and five female-to-male jumper wires. The dock must be powered off, with no power supply connected to the board, when updating FW.

The manual shows the component side and back side of the Intel USB4 Evaluation Dock, including the 50-pin debug header, GR/DBR JTAG, PCIe slots, DCin (20V), SWD headers and NVM locations. It provides example BKC file names, a GoshenRidge FW update example with batch operation settings, and Cypress CCG5 FW update steps with the pin mapping between the MiniProg4 and the J4 connector, plus notes on what to do when a FAIL message appears.

Read online

Intel USB4 Evaluation Dock specifications

DC input20V
Goshen Ridge NVM componentU8 – GR NVM
Delta Bridge NVM componentUB10 – DB NVM
USB2.0 Hub NVM componentUB6 – USB2 HUB NVM
Cypress DMC connectorJ5
Cypress CCG5 connectorJ4

Source: Intel USB4 Evaluation Dock Firmware Update Manual

All Intel USB4 Evaluation Dock documents by type

User Manual 2

Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.

Questions answered in these manuals

Should the Intel USB4 Evaluation Dock be powered while updating firmware?

No. Intel states the dock should be powered off, with no power supply connected to the board, when updating FW.

From: Intel USB4 Evaluation Dock Firmware Update Manual

What equipment is needed for the firmware update?

A Dediprog SF600 SPI NOR Flash Programmer with an ISP-TC-8 test clip, a Cypress MiniProg4 Program and Debug Kit CY8CKIT-005, and five female-to-male external jumpers.

From: Intel USB4 Evaluation Dock Firmware Update Manual

How many TBT DFPs does the Intel USB4 Evaluation Dock support?

It supports x3 TBT DFPs up to 40Gbps, and it also supports TBT and non-TBT host connection.

From: Intel USB4 Evaluation Dock EVB Rev 4v0 User Manual

What DC adapter rating is required for normal operation?

A DC adapter shall be used for normal operation, and a minimum of 120W (19v @ 6.3A) shall be used.

From: Intel USB4 Evaluation Dock EVB Rev 4v0 User Manual