Intel USB4 Evaluation Dock Firmware Update Manual

Firmware update guide for the Intel USB4 Evaluation Dock, covering Dediprog SF600 and Cypress MiniProg4 tools, component locations and update steps.


Intel USB4 Evaluation Dock Firmware Update Manual - cover page
Brand
Intel
Category
Board
Document type
User Manual
Language
English
Pages
32
File format
PDF
File size
3.4 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
9C045545CE6DC89ACA7799B445008BB5

About this manual

This Intel manual describes how to update firmware on the Intel USB4 Evaluation Dock, covering the components Goshen Ridge (U8 – GR NVM), Delta Bridge (UB10 – DB NVM), USB2.0 Hub (UB6 – USB2 HUB NVM), Cypress DMC (J5) and Cypress CCG5 (J4). It lists the required equipment: a Dediprog SF600 SPI NOR Flash Programmer with an ISP-TC-8 (SO8) test clip, a Cypress MiniProg4 Program and Debug Kit CY8CKIT-005, and five female-to-male jumper wires. The dock must be powered off, with no power supply connected to the board, when updating FW.

The manual shows the component side and back side of the Intel USB4 Evaluation Dock, including the 50-pin debug header, GR/DBR JTAG, PCIe slots, DCin (20V), SWD headers and NVM locations. It provides example BKC file names, a GoshenRidge FW update example with batch operation settings, and Cypress CCG5 FW update steps with the pin mapping between the MiniProg4 and the J4 connector, plus notes on what to do when a FAIL message appears.

What's inside

  • Equipment
  • Dediprog SF600 SPI NOR Flash Programmer
  • ISP Testclip (SO8) ISP-TC-8
  • Cypress MiniProg4 Program and Debug Kit CY8CKIT-005
  • Component Side and Back Side of Intel USB4 Evaluation Dock
  • BKC File example
  • GoshenRidge FW Update
  • Cypress CCG5 FW Update

Specifications

DC input20V
Goshen Ridge NVM componentU8 – GR NVM
Delta Bridge NVM componentUB10 – DB NVM
USB2.0 Hub NVM componentUB6 – USB2 HUB NVM
Cypress DMC connectorJ5
Cypress CCG5 connectorJ4

Frequently asked questions

Should the Intel USB4 Evaluation Dock be powered while updating firmware?

No. Intel states the dock should be powered off, with no power supply connected to the board, when updating FW.

What equipment is needed for the firmware update?

A Dediprog SF600 SPI NOR Flash Programmer with an ISP-TC-8 test clip, a Cypress MiniProg4 Program and Debug Kit CY8CKIT-005, and five female-to-male external jumpers.

How many CCG5 firmware files are used for CCG5 AB and CCG5 CD?

Only one file is used; the same CCG5 hex file is loaded for both CCG5 AB and CCG5 CD.

What should I do if PSOC Programmer reports FAIL?

Check the connection between the Cypress MiniProg4 and the header; if it is correct and FAIL still appears, close PSOC Programmer, detach and reattach the MiniProg4 to the host, then reopen the application.

What is the pin mapping for the CCG5 AB connector?

The MiniProg4 SWDIO goes to pin 10, SWCLK to pin 9, XRES to pin 8, GND to pin 7 and VTARG to pin 6.

Download PDF (3.4 MB)

More Intel Manuals


View all Intel manuals →