Key facts
Start here

Panasonic FX-100 Series Digital Fiber Sensor User Manual
This manual explains how to connect the sensor using the CN-14A-C cable, describes the RUN, SET, and PRO modes, and details the lock key function to prevent accidental changes. It also covers installation on DIN rails, cable handling, and safety precautions for industrial use.
Technical specifications such as power supply voltage, current limits, output types, response times, and environmental limits are listed, along with troubleshooting guidance for error codes and instructions for copying settings between master and slave units. This manual is written in Chinese.
Panasonic FX-100 Series specifications
| Power supply voltage | 12–24 V DC ±10 % |
|---|---|
| Typical power consumption (24 V) | ≤720 mW (30 mA) |
| ECO mode power consumption (24 V) | ≤600 mW (25 mA) |
| Maximum input current (NPN type) | 100 mA |
| Maximum output current (PNP type) | 100 mA |
| Input impedance (NPN) | ≈10 kΩ |
| Response time (投光频率 0) | ≤250 µs |
Source: Panasonic FX-100 Series Digital Fiber Sensor User Manual
All Panasonic FX-100 Series documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
How do I connect the sensor cable?
Insert the connector‑equipped cable CN-14A-C into the connector part as shown in the diagram, pressing the unlock lever while pulling the cable.
From: Panasonic FX-100 Series Digital Fiber Sensor User Manual
What is the allowed power supply voltage range?
The sensor operates on a 12 V to 24 V DC supply with a tolerance of ±10 %.
From: Panasonic FX-100 Series Digital Fiber Sensor User Manual
How far can the sensor cable be extended?
The cable can be extended up to 100 m using a cable of 0.3 mm² or larger, and should be kept as short as possible to reduce noise effects.
From: Panasonic FX-100 Series Fiber Optic Digital Sensor Instruction Manual
What tightening torque should be used when mounting with screws?
Use M3 screws with nuts and do not apply more than 0.5 N·m so that the housing is not broken.
From: Panasonic FX-100 Series Fiber Optic Digital Sensor Instruction Manual
