Key facts
- Brand
- DELL
- Model
- PowerEdge 1850
- Category
- Servers Computer
- Documents
- 3
- Languages
- EN
- Last added
- 2023-11-22
Start here

Dell PowerEdge 1850 Systems Installation and Troubleshooting Guide
This Dell publication provides installation and troubleshooting instructions for the Dell PowerEdge 1850 system. It covers system indicators, messages, codes, software solutions, diagnostics, and getting help.
The guide also explains how to install system components and drives, configure jumpers and switches, and use the system board, riser board, SCSI backplane, and I/O connectors.
Dell PowerEdge 1850 specifications
| Serial connector type | 9-pin D-subminiature |
|---|---|
| USB maximum current per channel | 500 mA or +5 V |
| Coin battery voltage | 3.0 V |
| Video connector type | 15-pin high-density D-subminiature |
| PS/2 keyboard and mouse connector type | 6-pin miniature DIN |
Source: Dell PowerEdge 1850 Systems Installation and Troubleshooting Guide
All Dell PowerEdge 1850 documents by type
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Disassembly, diagnostics and part numbers, for repair.
Questions answered in these manuals
How is a forgotten system password disabled?
Remove the password jumper plug, boot the system, then reinstall the jumper and assign a new password using the System Setup program.
From: Dell PowerEdge 1850 Systems Installation and Troubleshooting Guide
What is the default designation of the integrated serial connector?
The integrated serial connector is designated as COM1 by default.
From: Dell PowerEdge 1850 Systems Installation and Troubleshooting Guide
What is the first step in removing the SCSI backplane board?
If applicable, remove the bezel.
From: Dell PowerEdge 1850 Systems Service-Only Parts Replacement Procedures
What must be done before removing the SCSI backplane board?
You must remove the SCSI drives from the system before removing the backplane.
From: Dell PowerEdge 1850 Systems Service-Only Parts Replacement Procedures
What should I do if I see a 'failure to load usb‑ohci driver' message on Red Hat Enterprise Linux 2.1?
Remove the line that loads usb‑ohci from /etc/modules.conf, or upgrade the system to Red Hat Enterprise Linux 2.1 Update 4 which resolves the issue.
