Industrial

TS971-TS972-TS974 are low noise operational amplifiers from TI with a working voltage range of 2.7V-10V. They feature extremely low noise and distortion, making them suitable for portable and battery-powered equipment.

VESD05A4A-HS4 is a 4-line ESD protection diode array in LLP1010-5L package. It features low leakage current, low load capacitance, and strong ESD protection capability.

UCC28C4x family are high performance current mode PWM controllers featuring 2.3 mA operating current, 25 ns rise and 20 ns fall time rail-to-rail output swings, ±1 A peak output current, 35 ns cycle-by-cycle overcurrent limiting, 1 MHz operation, suitable for switch mode power supplies, DC-DC converters and board mount power modules.

TOIM4232 is a product of Vishay Semiconductors. It is an integrated interface circuit for SIR IrDA® applications that can perform pulse shortening and stretching.

This document is the datasheet of LH1510AAB/AABTR/AT solid state relay from Vishay Semiconductors. The product has high reliability monolithic output die, low power consumption, clean, bounce-free switching, high surge capability and other features. The product has passed UL1577, CSA, BSI/BABT, DIN EN 60747-5-2, DIN EN 60747-5-5, FIMKO certification, and is suitable for general telecom switching, instrumentation, industrial control and other fields.

This document describes the development system of MICRFXXX series radio frequency transceivers, including system composition, input and output, DIP switch settings, getting started, RF test modes, 2-way Link Test Mode, Byte Transfer Modes, Simple Byte Transfer Mode, Advanced Byte Transfer Mode, PC program, firmware upgrade, etc.

The ACS712 is an economical and precise AC or DC current sensor, suitable for industrial, automotive, commercial, and communications systems. It provides a linear output that varies with the sensed current, and has low offset. Typical applications include motor control, load detection and management, switched-mode power supplies, and overcurrent fault protection.

SFH6700/ 01/ 02/ 05/ 11/ 12/ 19 is a high speed optocoupler produced by Vishay Semiconductors, with a data rate of 5MBd, 1kV/µs dV/dt, TTL, LSTTL and CMOS compatible, providing three-state output (SFH6700/19), open collector output (SFH6705), and is used in industrial control, pulse transformer replacement, routine logic interface, motion/power control, high speed line receiver, microprocessor system interface, computer peripheral interface and other occasions.

This is a hardware user manual for Blackfin CM-BF537E, which details the product's functional features, specifications, dimensions, software support and more.

This document introduces the characteristics and features of the DS679A2 low power stereo codec produced by Cirrus Logic. The codec has a dynamic range of 98 dB and a THD+N of -86 dB, supports stereo headphone amplifiers, digital signal processing engines, beep generators, peak detection and limiters, automatic level control, noise gates, digital volume controls, etc.

OX16C954 is a high performance UART chip produced by Oxford Semiconductor, it has four independent full-duplex asynchronous 16C950 high performance UART channels, 128-byte deep FIFO, programmable Xon/Xoff characters, programmable special character detection, programmable flow control, 5, 6, 7, 8 and 9-bit data framing, sleep mode and other features.

Littelfuse AC series two-electrode line protectors provide a high degree of surge protection in AC line applications. The two models, AC120 and AC240 are designed for use with 120VAC and 240VAC lines respectively. They are able to extinguish AC follow-on currents of at least 200A. Littelfuse CG3 two electrode high voltage (1.0 - 7.5 KV) devices are designed for surge protection and high isolation applications, and for applications for which bias voltages or signal levels of several hundred volts are normally present.

The LT1934/LT1934-1 is a micropower step-down DC/DC converter with internal 400mA power switch, packaged in a low profile (1mm) ThinSOT. With its wide input range of 3.2V to 34V, the LT1934 can regulate a wide variety of power sources, from 4-cell alkaline batteries and 5V logic rails to unregulated wall transformers and lead-acid batteries. Quiescent current is just 12μA and a zero current shut- down mode disconnects the load from the input source, simplifying power management in battery-powered sys- tems. Burst Mode® operation and the low drop internal power switch result in high efficiency over a broad range of load current. The LT1934 provides up to 300mA of output current. The LT1934-1 has a lower current limit, allowing optimum choice of external components when the required output current is less than 60mA. Fast current limiting protects the LT1934 and external components against shorted outputs, even at 34V input.

This is a hardware manual for RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / R8C /Tiny SERIES R8C/12 Group 16

The TSOP312.. series are miniaturized receivers for infrared remote control systems. PIN diode and preamplifier are assembled on lead frame, the epoxy package is designed as IR filter. The demodulated output signal can directly be decoded by a microprocessor. TSOP312.. is the stan- dard IR remote control receiver series for 3 V supply voltage, supporting all major transmission codes.