Industrial

This document introduces the features and characteristics of MCP201 products, including supported baud rates, power supply voltage range, working temperature range, interface standards, etc.

The LT3470 is a micropower step-down DC/DC converter that integrates a 300mA power switch, catch diode and boost diode into low profile 3mm x 2mm DD and ThinSOT packages. The LT3470 combines Burst Mode and continuous operation to allow the use of tiny inductor and capacitors while providing a low ripple output to loads of up to 200mA. With its wide input range of 4V to 40V, the LT3470 can regulate a wide variety of power sources, from 2-cell Li-Ion batteries to unregulated wall transformers and lead- acid batteries. Quiescent current in regulation is just 26µA in a typical application while a zero current shutdown mode disconnects the load from the input source, simpli- fying power management in battery-powered systems.

This file is a user manual for Carel products, introduces the characteristics and usage methods of the products.

This document introduces a full-featured industrial plug-in relay that serves as a single pole interface to four pole power switching, enabling low level signal to high power DC switching. It offers options for latching and low consumption coil, as well as plug-in timer cube.

This document provides detailed information on power considerations, AC/DC electrical characteristics, and AC timing specifications for revision A,B, and C of the MPC850 Family

The LM6171 is a high speed unity-gain stable voltage feedback amplifier. It offers a high slew rate of 3600V/µs and a unity-gain bandwidth of 100 MHz while consuming only 2.5 mA of supply current. The LM6171 has very impressive AC and DC performance which is a great benefit for high speed signal processing and video applications. The ±15V power supplies allow for large signal swings and give greater dynamic range and signal-to-noise ratio. The LM6171 has high output current drive, low SFDR and THD, ideal for ADC/DAC systems. The LM6171 is specified for ±5V operation for portable applications. The LM6171 is built on National’s advanced VIP™ III (Vertically Integrated PNP) complementary bipolar process.

GAL20V8 is a high-performance E2CMOS PLD (programmable logic device) from Lattice Semiconductor Corp. It has a maximum propagation delay of 5 ns and a maximum operating frequency of 166 MHz. The device uses UltraMOS advanced CMOS technology, with power consumption 50% to 75% lower than that of bipolar devices. Typical current for low-power devices is 75mA, and typical current for quarter-power devices is 45mA. In addition, the device has active pull-ups on all pins, reconfigurable logic, reprogrammable cells, 100% tested / 100% yields, high-speed electrical erasure (<100ms), and 20-year data retention.

The MC68EC030 is a 32-bit embedded controller that streamlines the functionality of an MC68030 for the requirements of embedded control applications. The MC68EC030 is optimized to maintain performance while using cost-effective memory subsystems. The rich instruction set and addressing mode capabilities of the MC68020, MC68030, and MC68040 have been maintained, allowing a clear migration path for M68000 systems.

PPC-5050A 15” TFT Panel PC Ver 1.0 manual

The TPA2005D1 is a 1.4-W high-efficiency filter-free class-D audio power amplifier in a MicroStar Junior™ BGA, QFN, or MSOP package that requires only three external components.

The LTC2053 is a high precision instrumentation amplifier with adjustable gain, low offset voltage, and small temperature drift. It is suitable for applications such as thermocouple amplifiers, electronic scales, and medical instrumentation.

This document is the specifications of PSA1310V2, Ap1200PSAV2 and Ap800PSAV2 power supply adapters produced by Able Systems Limited.

The IR2114/IR2214 gate driver family is suited to drive a single half bridge in power switching applications. These drivers provide high gate driving capability and require low quiescent current. They feature full short circuit protection and smoothly turn off the desaturated transistor through the dedicated soft shutdown pin, preventing over-voltages and reducing EM emissions.

CEAG AG/FRIWO Group is a leading global provider of power supplies, continuously developing high-quality products with innovative design and technical expertise. They have a reliable and experienced industry partnership worldwide. Over 930 million power supplies and chargers have been sold in 33 years, demonstrating their high level of expertise and innovation.