Key facts
- Brand
- Danfoss
- Model
- VLT® PROFIBUS DP MCA 101
- Category
- Industrial Robot
- Industry
- Industrial
- Documents
- 2
- Languages
- EN
- Last added
- 2026-11-15
Start here

Danfoss VLT PROFIBUS DP MCA 101 Programming Guide
The VLT® PROFIBUS DP MCA 101 Programming Guide provides instructions for qualified personnel to configure the system, control the frequency converter, access parameters, and perform programming tasks. It details the setup of the PROFIBUS network, including GSD files and master configuration, as well as specific control profiles like PROFIdrive and Danfoss FC.
Read onlineAll Danfoss VLT® PROFIBUS DP MCA 101 documents by type
Mounting, wiring and first power-up. Read it before the hardware goes in.
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What drives is the VLT® PROFIBUS DP MCA 101 intended for use with?
The interface is intended for use with VLT® HVAC Drive FC 102, VLT® Refrigeration Drive FC 103, VLT® AQUA Drive FC 202, VLT® AutomationDrive FC 301/FC 302, VLT® DriveMotor FCP 106, and VLT® DriveMotor FCM 106.
What is the minimum required clearance between power, motor, and control cables?
A minimum clearance of 200 mm (7.9 in) is required between power, motor, and control cables.
What personnel are authorized to install and operate this equipment?
Only qualified personnel, defined as trained staff authorized to install, commission, and maintain equipment in accordance with laws and regulations, are allowed to perform these tasks.
What is the minimum waiting time required after disconnecting power before performing service?
The text states that the minimum duration of waiting time is specified in the Safety chapter of the operating instructions supplied with the frequency converter.
