Installation guide for Danfoss VLT® PROFIBUS DP MCA 101, covering safety, mounting, wiring, and troubleshooting for qualified personnel.
This guide provides step-by-step instructions for installing the VLT® PROFIBUS DP MCA 101 interface in compatible Danfoss frequency converters. It covers safety precautions, EMC-compliant installation, grounding, cable routing, mounting procedures, and troubleshooting common issues. The guide assumes users are qualified and familiar with the VLT® frequency converter and PROFIBUS technology.
The interface supports PROFIBUS DP-V1 and is designed for use with specific Danfoss drive models including FC 102, FC 103, FC 202, FC 301/302, FCP 106, and FCM 106. It requires a PROFIBUS master compliant with the PROFIdrive profile and appropriate software for configuration.
The interface is intended for use with VLT® HVAC Drive FC 102, VLT® Refrigeration Drive FC 103, VLT® AQUA Drive FC 202, VLT® AutomationDrive FC 301/FC 302, VLT® DriveMotor FCP 106, and VLT® DriveMotor FCM 106.
A minimum clearance of 200 mm (7.9 in) is required between power, motor, and control cables.
When the fieldbus cable intersects a motor cable or a brake resistor cable, the cables must intersect at an angle of 90°.