Rockwell Automation MicroLogix 1400 Error -3: Undefined Accel/Decel

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code-3

Acceleration and deceleration counts are not defined when Accel/Decel Pulses Independent is set to 1. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Undefined Accel/Decel (-3)
Type
Error code
Source
Manual p. 106

What -3 means

Undefined Accel/Decel p. 106

Common causes

  • Acceleration Count and Deceleration that are not defined during going to Run mode when Accel/Decel Pulses Independent (ADI) is set (1). p. 106

If -3 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about -3; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.