Rockwell Automation MicroLogix 1400 Error 0: Normal

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code0

No error is present when a hard stop is detected, and it does not fault the controller. The manual's first action is: “To clear this error, scan the PTOX instruction on a false rung and reset the EH (Enable Hard Stop) bit to 0.”

Model
Rockwell Automation MicroLogix 1400
Display shows
Normal (0)
Type
Error code
Source
Manual p. 106

What 0 means

Normal p. 106

Common causes

  • This error is generated whenever a hard stop is detected. This error does not fault the controller. p. 106
  • Normal (0 = no error present) p. 106
  • The instruction completed successfully. p. 106
  • No error found p. 106
  • Normal condition. p. 106

What to do

  1. To clear this error, scan the PTOX instruction on a false rung and reset the EH (Enable Hard Stop) bit to 0. p. 106
  2. None Required, p. 106

Before you service the product, read the safety instructions in the manual p. 274.

If 0 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 0; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.