Rockwell Automation MicroLogix 1400 Error 6: Jog Frequency Error

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code6

The jog frequency value exceeds valid limits, causing a controller fault. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Jog Frequency Error (6)
Type
Error code
Source
Manual p. 106

What 6 means

Jog Frequency Error p. 106

Common causes

  • The jog frequency (JF) value is less than 0 or greater than 100,000. This error faults the controller. It can be cleared by logic within the User Fault Routine. p. 106
  • Socket error during Send operation p. 106
  • The file number being referenced is not the proper file type. p. 106

If 6 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 6; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.