Rockwell Automation MicroLogix 1400 Error -2: Overlap Error

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code-2

Multiple functions are assigned to the same physical output, causing a configuration error that faults the controller. The manual's first action is: “The controller faults and the User Fault Routine do not execute. Example: PWM0 and PWM1 are both attempting to use a single output.”

Model
Rockwell Automation MicroLogix 1400
Display shows
Overlap Error (-2)
Type
Error code
Source
Manual p. 106

What -2 means

Overlap Error p. 111

Common causes

  • An output overlap is detected. Multiple functions are assigned to the same physical output. This is a configuration error. The controller faults and the User Fault Routine do not execute. p. 111
  • An output overlap is detected. Multiple functions are assigned to the same physical output. p. 111

What to do

  1. The controller faults and the User Fault Routine do not execute. Example: PWM0 and PWM1 are both attempting to use a single output. p. 111

Before you service the product, read the safety instructions in the manual p. 274.

If -2 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about -2; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.