Rockwell Automation MicroLogix 1400 Error -1: Output Error

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code-1

An invalid output (not 2, 3, or 4) has been specified, causing a configuration error that faults the controller. The manual's first action is: “Output 2, output 3, and output 4 are the only valid choices. This is a configuration error. The controller faults and the User Fault Routine do not execute.”

Model
Rockwell Automation MicroLogix 1400
Display shows
Output Error (-1)
Type
Error code
Source
Manual p. 106

What -1 means

Output Error p. 111

Common causes

  • An invalid output has been specified. Output 2, Output 3, and Output 4 are the only valid choices. This is a configuration error. The controller faults and the User Fault Routine do not execute. p. 111
  • An invalid output has been specified. p. 111

What to do

  1. Output 2, output 3, and output 4 are the only valid choices. This is a configuration error. The controller faults and the User Fault Routine do not execute. p. 111

Before you service the product, read the safety instructions in the manual p. 274.

If -1 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about -1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.