Rockwell Automation MicroLogix 1400 Error 1: Invalid File Number

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code1

An invalid output (not 2, 3, or 4) has been specified, causing a configuration error that faults the controller. The manual's first action is: “To clear this error, scan the PTOX instruction on a false rung and reset the EH (Enable Hard Stop) bit to 0.”

Model
Rockwell Automation MicroLogix 1400
Display shows
Invalid File Number (1)
Type
Error code
Source
Manual p. 76

What 1 means

Invalid File Number p. 106

Common causes

  • Interrupt (program) file identified in HSC:0.PFN is less than 3, greater than 255, or does not exist p. 106
  • This error is generated whenever a hard stop is detected. p. 106
  • Program file number is less than 3, greater than 255, or does not exist p. 106
  • Socket error during Create operation p. 106
  • The retentive trimpot value crashed by external failure as like battery fault error. p. 106
  • The controller does not support Broadcast. p. 106

What to do

  1. To clear this error, scan the PTOX instruction on a false rung and reset the EH (Enable Hard Stop) bit to 0. p. 106
  2. It is automatically cleared when the hard stop condition is removed. p. 106

Before you service the product, read the safety instructions in the manual p. 274.

If 1 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.