Rockwell Automation MicroLogix 1400 Error 1H

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code1H

Loop update time O1 is out of range (0 or greater than 1024), requiring adjustment. The manual's first action is: “Change loop update time 0 < O1 ≤ 1024”

Model
Rockwell Automation MicroLogix 1400
Display shows
1H
Type
Error code
Source
Manual p. 231

What 1H means

Loop update time O1 > 1024 p. 231

Common causes

  • Loop update time O1 > 1024 p. 231
  • Loop update time O1 = 0 p. 231

What to do

  1. Change loop update time 0 < O1 ≤ 1024 p. 231

Before you service the product, read the safety instructions in the manual p. 274.

If 1H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 1H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.