Rockwell Automation MicroLogix 1400 Error 3: Invalid High Preset

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code3

Acceleration and deceleration counts are not defined when Accel/Decel Pulses Independent is set to 1. The manual's first action is: “Check the modem and modem connections.”

Model
Rockwell Automation MicroLogix 1400
Display shows
Invalid High Preset (3)
Type
Error code
Source
Manual p. 76

What 3 means

Invalid High Preset p. 258

Common causes

  • High preset is less than or equal to zero p. 258
  • The operating frequency value (OFS) is less than 0 or greater than 100,000. This error faults the controller. It can be cleared by logic within the User Fault Routine. p. 258
  • EILs cannot share each of these elements (EIL:0, EIL:1, EIL:2, EIL:3, EIL:4, EIL:5, EIL6 and EIL7) is inputs. Each EIL must have a unique input. p. 258
  • The transmission cannot be completed because the CTS signal was lost. p. 258
  • Socket error during Bind operation p. 258
  • The Modbus Command is the wrong size. p. 258

What to do

  1. Check the modem and modem connections. p. 258

Before you service the product, read the safety instructions in the manual p. 274.

If 3 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 3; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.