Rockwell Automation MicroLogix 1400 Error 5: Invalid Underflow

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code5

Low preset underflow or multiple jog states are active, causing an error without controller fault. The manual's first action is: “Reconfigure the channel and retry operation.”

Model
Rockwell Automation MicroLogix 1400
Display shows
Invalid Underflow (5)
Type
Error code
Source
Manual p. 76

What 5 means

Invalid Underflow p. 258

Common causes

  • Low preset is less than underflow p. 258
  • PTOX is in the idle state and two or more of the following are set: • Enable (EM) bit set, • Jog Pulse (JP) bit set, • Jog Continuous (JC) bit set. This error does not fault the controller. It is automatically cleared when the error condition is removed. p. 258
  • While attempting to perform an ASCII transmission, a conflict with the configured communications protocol was detected. p. 258
  • Socket error during Connect operation p. 258
  • The function cannot be executed with these parameters. p. 258

What to do

  1. Reconfigure the channel and retry operation. p. 258

Before you service the product, read the safety instructions in the manual p. 274.

If 5 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 5; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.