Rockwell Automation MicroLogix 1400 Error 4: Invalid Overflow

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code4

The accelerator/decelerate parameters exceed limits or overflow conditions occur, causing a controller fault. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Invalid Overflow (4)
Type
Error code
Source
Manual p. 76

What 4 means

Invalid Overflow p. 76

Common causes

  • High preset is greater than overflow p. 76
  • The accelerator/decelerate parameters (AOP) are: • less than zero, • greater than half the total output pulses to be generated (TOP). • Accel/Decel exceeds limit. (See page 103). This error faults the controller. It can be cleared by logic within the User Fault Routine. p. 76
  • Socket error during Accept operation p. 76
  • The function attempted to read/write past the end of a data file. p. 76

If 4 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 4; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.