Rockwell Automation MicroLogix 1400 Error 2: Invalid Mode

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code2

Multiple functions are assigned to the same physical output, causing a configuration error that faults the controller. The manual's first action is: “The forced condition must be removed. This error does not fault the controller. It is automatically cleared when the force condition is removed.”

Model
Rockwell Automation MicroLogix 1400
Display shows
Invalid Mode (2)
Type
Error code
Source
Manual p. 76

What 2 means

Invalid Mode p. 106

Common causes

  • Invalid Mode p. 106
  • The configured PTOX output (2, 3 or 4) is forced for the PTOX to operate. p. 106
  • The configured PWMX output (2, 3, or 4) is forced. The forced condition must be removed for the PWMX to operate. p. 106
  • Valid numbers must be 0, 1, 2, 3, 4, 5, 6, or 7. p. 106
  • Socket error during Listen operation p. 106
  • The trimpot range of new program is range over. p. 106
  • The controller does not support this Modbus function or subfunction. p. 106

What to do

  1. The forced condition must be removed. This error does not fault the controller. It is automatically cleared when the force condition is removed. p. 106
  2. This error does not fault the controller. It is automatically cleared when the force condition is removed. p. 106

Before you service the product, read the safety instructions in the manual p. 274.

If 2 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 2; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.