Rockwell Automation MicroLogix 1400 Error 2H: Proportional gain Kc < 0

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code2H

Proportional gain Kc is set to a negative value, which is invalid for control operation. The manual's first action is: “Change proportional gain Kc to 0 < Kc”

Model
Rockwell Automation MicroLogix 1400
Display shows
Proportional gain Kc < 0 (2H)
Type
Error code
Source
Manual p. 231

What 2H means

Proportional gain Kc < 0 p. 231

Common causes

  • Proportional gain Kc < 0 p. 231

What to do

  1. Change proportional gain Kc to 0 < Kc p. 231

Before you service the product, read the safety instructions in the manual p. 274.

If 2H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 2H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.