Industrial

The UC1842/3/4/5 family is a current mode PWM controller optimized for off-line and DC to DC converters. It features low start-up current, automatic feed forward compensation, pulse-by-pulse current limiting, enhanced load response characteristics, etc.

U630H16 is a fast static RAM (25, 35, 45 ns) with a nonvolatile electrically erasable PROM (EEPROM) element incorporated in each static memory cell. The SRAM can be read and written an unlimited number of times, while independent nonvolatile data resides in EEPROM. Data transfers from the SRAM to the EEPROM (the STORE operation), or from the EEPROM to the SRAM (the RECALL operation) are initiated through the state of the NE pin.

TZM5221B and TZM5267B are silicon Z diodes produced by Vishay Telefunken. They feature very sharp reverse characteristics, very high stability, electrical data identical to the devices 1N5221B and 1N5267B, low reverse current level and ±5% VZ tolerance. Their applications include voltage stabilization.

TSAL7300 Vishay Telefunken is a high efficiency infrared emitting diode in GaAlAs on GaAs technology, molded in clear, plastic packages.

The TSA1002 is a 10-bit A/D converter manufactured using CMOS technology, combining high performance and low power consumption. It provides 9.4 effective bits at a sampling frequency of 50Msps and has a maximum SFDR of 72dB. The converter has a built-in reference voltage and can be externally biased. It is designed for high-speed, low-power applications and consumes only 50mW at 50Msps.

This document describes the features and characteristics of the TPS775xx and TPS776xx series products, including fast transient response, 500mA low-dropout voltage regulator, adjustable and fixed output versions, etc.

This document introduces the TPS755xx family of 5A low dropout regulators, which includes four fixed voltage option regulators with integrated power-good (PG) and an adjustable voltage option regulator. These devices are capable of supplying 5A of output current with a dropout of 250mV (TPS75533). Therefore, the device is capable of performing a 3.3V to 2.5V conversion. At full load, quiescent current is 125µA and drops down to less than 1µA when the device is disabled. The TPS755xx is designed to have fast transient response for large load current changes.

The TPS6030x is a high-efficiency charge pump that converts a single-cell voltage to 3.0V/3.3V. It features a regulated 3V or 3.3V output voltage with up to 20mA output current. It is optimized for 1.2V battery voltage and achieves up to 90% power conversion efficiency. The product does not require an inductor and only needs five small 1uF ceramic capacitors to build a complete high-efficiency DC/DC charge pump converter.

The document introduces TPS54073, a low-input voltage, high-output current synchronous buck PWM converter. It features 8-mΩ MOSFET switches for high efficiency operation. The converter integrates all required active components, including a true high-performance voltage error amplifier, undervoltage-lockout circuit, internally/externally set slow-start circuit, and power good output.

This file is the application guide for TPS2398/TPS2399, introducing the main features and application scenarios of the product

The TPS2223A, TPS2224A, and TPS2226A CardBus™ power-interface switches provide an integrated power-management solution for two PC Card sockets. The TPS2220A is a single-slot option for this family of devices. These devices allow the controlled distribution of 3.3 V, 5 V, and 12 V to each card slot. The current-limiting and thermal-protection features eliminate the possibility of card failure due to overcurrent or overheating.

This document is the datasheet of the TMS320C80 digital signal processor from 1997, which describes the features and characteristics of the processor. The processor is a single-chip parallel multiple instruction/multiple data (MIMD) DSP capable of executing over two billion RISC-equivalent operations per second. It includes a master processor (MP), four parallel processors (PP), a transfer controller (TC), and a video controller (VC) among other components. It features a 32-bit RISC processor, IEEE-754 floating-point capability, instruction cache, data cache, and more. It also supports big-endian or little-endian operation, has 50K bytes of on-chip RAM, a 4G-byte address space, a 16.6-ns cycle time, and operates at 3.3V.

This document describes the features and characteristics of the MITSUBISHI THYRISTOR MODULES TM90SA-6 medium power general use non-insulated type, including average on-state current, repetitive peak reverse voltage, repetitive peak off-state voltage, etc.

TLV2352 consists of two independent, low-power comparators specifically designed for single power-supply applications and operates with power-supply rails as low as 2V. When powered from a 3V supply, the typical supply current is only 120µA. TLV2352 is designed using the Texas Instruments LinCMOS technology and therefore features an extremely high input impedance (typically greater than 1012Ω), which allows direct interfacing with high-impedance sources. The outputs are N-channel open-drain configurations that require an external pullup resistor to provide a positive output voltage swing, and they can be connected to achieve positive-logic wired-AND relationships.