Industrial

TLC2652, TLC2652A, TLC2652Y Advanced LinCMOS PRECISION CHOPPER-STABILIZED OPERATIONAL AMPLIFIERS

tl322c, tl322i low-power operational amplifiers datasheet

The TK6592x is a miniature electroluminescent (EL) lamp driver optimized for battery-controlled systems where power consumption and size are primary concerns.

The THS4211 is a low distortion, high speed, voltage feedback amplifier from TI that features unity gain stability, wide bandwidth (1GHz), high slew rate (970 V/μs), low distortion (-90 dBc THD @ 30 MHz) and high output drive (IO = 200 mA).

THS4011/12 290-MHz Low Distortion High-Speed Amplifiers are ideal high performance single/dual channel voltage feedback amplifiers for a wide range of applications.

The TCD series are radial lead ceramic capacitors from UCC/NCC. These capacitors have a very low ESR and impedance which makes these capacitors ideal for filtering switching power supplies and DC-DC converters. The TCD series has a maximum 250VDC rated voltage making them more applicable for use in higher voltage power supplies than our ceramic chip capacitors. All of our radial capacitors with 5mm lead spacing are also available with ammo pack taping. Refer to Mini-Glossary at the end of the multilayer ceramic capacitors section for additional technical information and specifications.

TC9208M is a fully integrated 8 port 10/100/1000 smart Ethernet switch controller designed for low cost and high performance solutions. The chip embeds necessary SSRAM for packet buffering and MAC address table. It provides MII / GMII interface for all ports. A store-and-forward switching method using a non-blocking architecture is implemented within TC9208M to improve the availability and bandwidth. The chip embeds packet buffer, which it supports normal and priority queues for each transmission port. TC9208M provides evolved CoS with four levels of priority. The priority can be checked via ip header and 802.1q vlan tag.

This document provides information about the TC74LCX157F supplier. Please visit www.AllDataSheet.com for more details.

The TC520A serial interface adapter provides logic control for Microchip's TC500/TC500A/TC510/TC514 family of dual slope, integrating A/D converters. It directly manages TC500 converter phase control signals A, B and CMPTR, thereby reducing host processor task loading and software complexity. Communication with the TC520A is accomplished over a 3 wire serial port. Key converter operating parameters are programmable for complete user flexibility. Data conversion is initiated when the CE input is brought low. The converted data (plus overrange and polarity bits) are held in an 18-bit shift register until read by the processor or until the next conversion is completed. Data may be clocked out of the TC520A at any time, and at any rate, the user prefers. A Data Valid (DV) output is driven active at the start of each conversion cycle, indicating the 18-bit shift register update has just been completed. This signal may be polled by the processor or can be used as...

TC4420 TC4429 is a high-speed 6A MOSFET driver with high peak output current, wide operating range, high output impedance, short delay time, low input current and low output voltage swing. It can be used in switch-mode power supplies, motor controls, pulse transformer drivers and class D switching amplifiers.

The T0782 is a high-linearity active mixer which is manufactured using Atmel’s advanced Silicon-Germanium technology. This mixer features a frequency range of 2200 MHz to 2700 MHz. It operates from a single 5-V supply and provides 10 dB of conversion gain while requiring only 0 dBm input to the integrated LO driver. An IF amplifier is also included. The T0782 incorporates internal matching on each RF, IF and LO port to enhance ease of use and to reduce the external components required. The RF and LO inputs can be driven differentially or single-ended.

This document describes the features and characteristics of the KLY-0010-000 1 SY3318-V high brightness LED lamp. The LED lamp features colorless transparency lens, φ3mm(T-1) all plastic mold type, and super luminosity.

This document is about 1/4 inch VGA CIS camera module SX5437M21X-X0B0's preliminary specification