Industrial

The LCX162244 is a low voltage 16-bit buffer/line driver with 26 ohm series resistors in outputs. It contains sixteen non-inverting buffers designed to be used as a memory and address driver, clock driver, or bus oriented transmitter/receiver. The device is nibble controlled, with separate 3-STATE control inputs for each nibble that can be shorted together for full 16-bit operation. The LCX162244 is designed for low voltage (2.5V or 3.3V) applications and can interface with a 5V signal environment. The outputs include equivalent 26 ohm series resistors to reduce overshoot and undershoot and can sink/source up to 12 mA at VCC = 3.0V. The LCX162244 is fabricated with advanced CMOS technology to achieve high speed operation while maintaining CMOS low power dissipation.

The 74LCX162244 is a low voltage CMOS 16-bit bus buffer (non-inverted) fabricated with sub-micron silicon gate and double-layer metal wiring C2MOS technology. It is ideal for low power and high-speed 3.3V applications; it can be interfaced to 5V signal environment for both inputs and outputs. Any nG output control governs four bus buffers. Output enable input (nG) tied together gives full 16-bit operation. When nG is low, the outputs are on. When nG is high, the outputs are in a high impedance state. This device is designed to be used with 3-state memory address drivers, etc. The device circuit includes 26Ω series resistance in the outputs. These resistors permit to reduce line noise in high-speed applications. All inputs and outputs are equipped with protection circuits against static discharge, giving them 2KV ESD immunity and transient excess voltage.

This document describes the method of HPLC analysis of glucocorticoids.

The document describes a low voltage 16-bit transparent latch from Fairchild Semiconductor Corporation, which has 5V tolerant inputs and outputs and a 26Ω series resistor. The product is designed for bus oriented applications and has byte control functionality. The flip-flops are transparent to the data when the Latch Enable (LE) is high. When LE is low, the data that meets the setup time is latched. Data appears on the bus when the Output Enable (OE) is low. When OE is high, the outputs are in a high impedance state. The product is designed for low voltage (2.5V or 3.3V) VCC applications with the capability of interfacing to a 5V signal environment. The 26Ω series resistor in the output helps reduce output overshoot and undershoot. The product is fabricated with an advanced CMOS technology to achieve high speed operation while maintaining CMOS low power dissipation.

This document describes the results of the separation of quercetin and kaempferol in ginkgo extract and tablets using HPLC.

This file introduces the application of HPLC in the analysis of water-soluble vitamins.

The document describes the analysis of tricyclic antidepressant drugs. Tricyclic antidepressants are tricyclic derivatives of diphenylamine or diphenylmethane and have mood-enhancing effects. Antidepressants inhibit the mechanism that inactivates these amines, resulting in a higher concentration at the corresponding receptors. They have parasympatholytic side effects that occur a few days after treatment. The desired antidepressant effects occur after two to three weeks.

The bq2063 SBS v1.1-compliant Li-Ion gas gauge IC provides accurate measurement of available charge in Li-Ion batteries. It supports the 2-Wire SMBus V1.1 interface with PEC or Single-Wire HDQ16. It directly interfaces the Seiko S-8243 protection IC for maximum safety protection and minimal component count. It supports internal or external thermistor and reports individual cell voltages. It uses a 15-Bit ADC for accurate voltage, temperature, and current measurements. It consumes less than 0.5 mW operating power and drives a 4- or 5-segment LED display for remaining capacity indication.

The document describes the HPLC analysis method for quinine and quinidine in cinchona bark extract. The cinchona bark contains 4-12% alkaloids, mainly the diastereomers quinine/quinidine and cinchonine/cinchonidine. Quinine is the major compound accounting for 80% of the total alkaloids in cinchona bark. It is a strong protoplasmic poison with effects on almost any cell. Quinine is used as an anti-malaria medicine. Some soft drinks, such as tonic water, contain up to 80 mg/l of quinine, which gives them a bitter taste.

This document introduces the application of HPLC technology in the analysis of hypnotic drugs, including separation methods, instrument conditions, etc.

The document describes two antihypertensive drugs: captopril and enalapril. They lower blood pressure by inhibiting the enzyme that converts angiotensin I into angiotensin II. The document also provides a method for analyzing these two drugs using high-performance liquid chromatography.

This document introduces the HPLC analysis method for androgen drugs

The document describes the features and characteristics of the bq2060A SBS-Compliant Gas Gauge IC, including accurate measurement of available charge in NiCd, NiMH, Li-Ion, and lead-acid batteries, support for SBS Smart Battery Data Specification v1.1, support for the 2-wire SMBus v1.1 interface, reporting of individual cell voltages, monitoring and control of charge and discharge FETs in Li-Ion protection circuit, 15-bit resolution for voltage, temperature, and current measurements, measurement of charge flow using a V-to-F converter with offset of less than 16µV after calibration, power consumption of less than 0.5mW, and driving a 4- or 5-segment LED display for remaining capacity indication.

The document describes the features and characteristics of bq2060 SBS-Compliant Gas Gauge IC, which provides accurate measurement of available charge in NiCd, NiMH, Li-Ion, and lead-acid batteries. It supports SBS Smart Battery Data Specification v1.1 and the 2-wire SMBus v1.1 interface.