Industrial

The MC10E/100E156 is a 3-BIT 4:1 MUX-LATCH circuit with differential outputs, asynchronous master reset, dual latch-enables, extended 100E VEE range of -4.2V to -5.46V, and 75kΩ input pulldown resistors.

This product is the MC10E/100E155 chip data sheet, which introduces the function characteristics, pin definition, logic diagram and other information of the chip.

This document is MC10E/100E155 datasheet, introduces the function and characteristics of the chip, including pin definition, logic diagram, truth table, characteristic parameters, etc.

The MC10E/100E151 is a 6-bit D register produced by Motorola. It has a minimum toggle frequency of 1100MHz, differential outputs, asynchronous master reset, dual clocks, an extended 100E VEE range from -4.2V to -5.46V, and 75kΩ input pulldown resistors.

The MC10E/100E151 is a 6-BIT D REGISTER produced by Motorola Corporation. It has 1100MHz Min. Toggle Frequency, Differential Outputs, Asynchronous Master Reset, Dual Clocks, Extended 100E VEE Range of – 4.2V to – 5.46V, 75kΩ Input Pulldown Resistors and other features.

The MC10E/100E150 is a 6-bit D latch with differential outputs. When both Latch Enables (LEN1, LEN2) are LOW, the latch is transparent and input data transitions propagate through to the output. A logic HIGH on either LEN1 or LEN2 (or both) latches the data. The Master Reset (MR) overrides all other controls to set the Q outputs low.

MC10E/100E150 is a 6-bit D latch with differential outputs produced by Motorola. When both Latch Enables (LEN1, LEN2) are LOW, the latch is transparent and input data transitions propagate through to the output. A logic HIGH on either LEN1 or LEN2 (or both) latches the data. The Master Reset (MR) overrides all other controls to set the Q outputs low.

The MC10E/100E143 is a 9-bit holding register, designed with byte-parity applications in mind. The E143 holds current data or loads new data, with the nine inputs D0 – D8 accepting parallel input data.

The MC10E/100E142 is a 9-bit shift register, designed with byte-parity applications in mind. The E142 performs serial/parallel in and serial/parallel out, shifting in one direction. The nine inputs D0 – D8 accept parallel input data, while S-IN accepts serial input data. The Qn outputs do not need to be terminated for the shift operation to function. To minimize noise and power, any Q output not used should be left unterminated.

MC10E/100E141 is an 8-bit full-function shift register. It performs serial/parallel in and serial/parallel out, shifting in either direction. The eight inputs D0-D7 accept parallel input data, while DL/DR accept serial input data for left/right shifting. The Qn outputs do not need to be terminated for the shift operation to function. To minimize noise and power, any Q output not used should be left unterminated.

The MC10E137/D is a 5 V ECL 8-bit oscillator/counter that can be used as a counter or oscillator. It has two asynchronous enable inputs and two synchronous enable inputs for maximum flexibility.

MC10E/100E136 is a 6-bit synchronous, presettable, cascadable universal counter. The device generates a look-ahead-carry output and accepts a look-ahead-carry input. These two features allow for the cacading of multiple E136’s for wider bit width counters that operate at very nearly the same frequency as the stand alone counter.