Philips manuals, page 102
PHILIPS KTY84-1 series Silicon temperature sensors handbook
This data sheet introduces the characteristics of the KTY84-1 series silicon temperature sensors, including temperature range, package, pin, marking, etc.
PHILIPS HEF4013B flip-flops Dual D-type flip-flop handbook
The HEF4013B is a dual D-type flip-flop which features independent set direct (SD), clear direct (CD), clock inputs (CP) and outputs (O, O). Data is accepted when CP is LOW and transferred to the output on the positive-going edge of the clock. The active HIGH asynchronous clear-direct (CD) and set-direct (SD) are independent and override the D or CP inputs. The outputs are buffered for best system performance. Schmitt-trigger action in the clock input makes the circuit highly tolerant to slower clock rise and fall times.
PHILIPS HEF40106B gates Hex inverting Schmitt trigger handbook
HEF40106B is a six-way inverting Schmitt trigger produced by Philips Semiconductors. This device can trigger at different points for the positive and negative-going input signals. The difference between the positive-going voltage (VP) and the negative-going voltage (VN) is defined as hysteresis voltage (VH). This device may be used for enhanced noise immunity or to “square up” slowly changing waveforms.
PHILIPS SA7026 1.3GHz low voltage fractional-N dual frequency synthesizer Data Sheet
SA7026 is a low voltage fractional-N dual frequency synthesizer, designed for pocket phones powered by 3 NiCd cells. The synthesizer features low phase noise, low power consumption, and fully programmable main and auxiliary dividers.
PHILIPS SAA7360 Bitstream conversion ADC for digital audio systems Data Sheet
The SAA7360 is a bitstream conversion ADC for digital audio systems. It features stereo input, single-ended input, uncommitted input buffer for filtering and pre-scaling, fully differential ADC using 3rd order Sigma-Delta modulation, 128 times oversampling, four stage digital decimation filter, switchable high-pass filter to remove DC offsets, selectable 16-bit or 18-bit output, and support for sampling rates between 18kHz and 53kHz.
Philips Semiconductors 87L51FA/87L51FB Data Sheet
This document describes the features and characteristics of Philips Semiconductors' 87L51FA and 87L51FB single-chip 8-bit microcontrollers.
PHILIPS PXT2222A handbook
This document is the datasheet of PXT2222A. PXT2222A is a NPN switching transistor with high current (max. 600 mA) and low voltage (max. 40 V). It is suitable for general purpose switching and linear amplification applications.
PHILIPS PR01/02/03 Professional power metal film resistors Data Sheet
This document is the product specification of BCcomponents PR01/02/03 Professional power metal film resistors, which introduces the features and performance of this product.
Philips Semiconductors NE/SE5537 Data Sheet
NE/SE5537 is an integrated operational amplifier manufactured by Philips Semiconductors. It uses dual power supply and operates over a voltage range of ±5V to ±18V. It features low leakage current, fast acquisition time and low droop rate.
PHILIPS MTW32N20E Data Sheet
This is a document of Motorola TMOS Power MOSFET Transistor Device Data. The device is an N-Channel Enhancement-Mode Silicon Gate MOSFET designed to withstand high energy in avalanche and commutation modes. It also features a drain-to-source diode with a fast recovery time, suitable for low voltage, high-speed switching applications in power supplies, converters, and PWM motor controls. The device is particularly well-suited for bridge circuits where diode speed and commutating safe operating areas are critical and offers additional safety margin against unexpected voltage transients.
PHILIPS TZA1015 Data amplifier laser supply circuit for CD read-only optical systems (HDALAS) handbook
TZA1015 is a data amplifier and laser supply circuit for CD and read-only optical systems (HDALAS) from Philips Semiconductors. It features six input buffer amplifiers with low-pass filtering and virtually no offset. It also features a universal photodiode IC interface, wide bandwidth RF data amplifier, programmable RF gain, programmable RF bandwidth, radial error signal, programmable RF/Fast Track Count (FTC) gain, fully automatic laser control, automatic monitor diode polarity selection, adjustable laser bandwidth and laser switch-on current slope, supply voltage range, temperature range and low power consumption.
Philips Semiconductors PHP80N06LT PHB80N06LT handbook
The document describes the features and characteristics of Philips Semiconductors' TrenchMOS transistors PHP80N06LT and PHB80N06LT, including low on-state resistance, fast switching, stable off-state characteristics, and high thermal cycling performance.
PHILIPS PESDxS2UQ series Double ESD protection diodes in SOT663 package handbook
PESDxS2UQ series double ESD protection diodes in SOT663 package. Features include uni-directional ESD protection, maximum peak pulse power Ppp = 150 W, low clamping voltage V(CL)R = 20 V, low reverse leakage current IRM < 1 nA, ESD protection > 30 kV, conforming to IEC 61000-4-2, level 4 (ESD) and IEC 61000-4-5 (surge) standards. Applications include computers and peripherals, communication systems, audio and video equipment, high speed data lines and parallel ports.
PHILIPS PDTA144EEF handbook
The PDTA144EEF is a PNP type transistor manufactured by Philips Semiconductors. It has built-in bias resistors R1 and R2, which can simplify circuit design and reduce the number of components and board space. This product is suitable for space reduction in interface and driver circuits and can be used in inverter circuit configurations without the use of external resistors.
philips BTA208 series C
This document describes the BTA208 series of three quadrant triacs from Philips Semiconductors. These triacs are designed for use in circuits where high static and dynamic dV/dt and dI/dt can occur. They feature glass passivation, high commutation capability, repetitive peak voltage, and maximum rated RMS current.