Key facts
- Brand
- Fluke
- Model
- T120
- Category
- Other Electronics
- Documents
- 2
- Languages
- ZH · EN
- Last added
- 2026-10-18
Start here
Fluke TNT 12000 DoseMate Quick Reference Guide
The Fluke TNT 12000 DoseMate is a detector designed to measure dose and dose rate precisely and quickly. The guide outlines the typical components of the system, including the X-ray test monitor, the DoseMate unit, and various ionization chambers (150 cc, 15 cc, and three-axis). It also includes safety warnings regarding electrical shock when connecting or disconnecting cables.
The document details step-by-step procedures for operating the device. Users are instructed on how to connect the ionization chamber, power on the system via USB or wireless connection, select specific ionization chambers and calibration coefficients, configure measurement modes (such as Dose mode with automatic reset), set units (R or Gy), and execute measurements while observing safety protocols. This manual is written in Chinese.
Fluke T120 specifications
| Voltage Measurement Range | DC and AC voltage measurement up to 690V |
|---|---|
| Operating Temperature | -10°C up to +55°C |
| Relative Humidity | <85% |
| Protection Rating | IP 65 |
Source: Fluke T100, T120, T140 VDE Voltage/Continuity Tester Users Manual
All Fluke T120 documents by type
The shortest path to a working setup, usually only a few pages.
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
What safety precaution is required before connecting or disconnecting the ionization chamber?
Turn off the DoseMate to prevent electrical shock or damage to the ionization chamber.
How can the DoseMate and monitor be connected?
The connection can be established via a USB cable or wirelessly.
What safety measures must be taken when working with voltages exceeding 75V DC or 50V AC?
The valid safety and VDE regulations regarding excessive contact voltages must receive utmost attention.
From: Fluke T100, T120, T140 VDE Voltage/Continuity Tester Users Manual
How can you verify the instrument is functioning correctly before use?
Short-circuit the probes; the Rx/Ohm LED must light up. If not, remove or replace the batteries.
From: Fluke T100, T120, T140 VDE Voltage/Continuity Tester Users Manual