Operating instructions for the JEOL JSM-IT200 scanning electron microscope, covering safety, sample setup, imaging, saving images and shutdown.
This guide provides operating instructions for the JEOL JSM-IT200 scanning electron microscope, covering safety, the instrument computer and file structure, sample preparation and loading, imaging, saving images, and finishing up.
The document describes the JSM-IT200 as a scanning electron microscope with a tungsten source capable of resolution below 10 nm and X-ray elemental dispersive spectroscopy for qualitative and quantitative elemental analysis. It notes that EDS controls are covered in a separate manual.
| Electron source | Tungsten source |
|---|---|
| Resolution | Below 10 nm |
| Elemental analysis | X-ray elemental dispersive spectroscopy |
| Filament type | Hairpin tungsten filament |
| Filament lifetime | Every few hundred hours |
| Standby vacuum | High vacuum when not in use |
It uses a hairpin tungsten filament as the electron source.
The document states it is capable of resolution below 10 nm.
Pause the Observation to turn off the gun, which helps prolong filament life.
Samples must be well secured and moderately conductive; powder samples should not be loaded loosely.