Rockwell Automation MicroLogix 1400 Error 4H: Derivative gain (rate) Td < 0

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code4H

Derivative gain rate Td is set to a negative value, which is invalid for control operation. The manual's first action is: “Change derivative gain (rate) Td to 0 ≤ Td”

Model
Rockwell Automation MicroLogix 1400
Display shows
Derivative gain (rate) Td < 0 (4H)
Type
Error code
Source
Manual p. 231

What 4H means

Derivative gain (rate) Td < 0 p. 231

Common causes

  • Derivative gain (rate) Td < 0 p. 231

What to do

  1. Change derivative gain (rate) Td to 0 ≤ Td p. 231

Before you service the product, read the safety instructions in the manual p. 274.

If 4H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 4H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.