Industrial

Memory Stick Connectors CB1 Series is a type of connector for connecting Memory Stick from Japanese connector manufacturer JST. There are three types: card push insert, card push insert and eject, and no eject.

The LM2937 is a positive voltage regulator capable of supplying up to 500 mA of load current. The use of a PNP power transistor provides a low dropout voltage characteristic. With a load current of 500 mA the minimum input to output voltage differential required for the output to remain in regulation is typically 0.5V (1V guaranteed maximum over the full operating temperature range).

SI-8200L/8300L series is an integrated switching IC and coil construction switch voltage regulator launched by Panasonic, it only requires 2 external components, low switching noise, no heatsink.

LNW9B2BZFZ round light emitting diode product information, including maximum working voltage, maximum working current, luminous color and other characteristics

This document describes a triple buffer/driver product with open-drain outputs. It supports 5V VCC operation and features low power consumption, high output drive capability, and ESD protection.

The µA78M00 series of positive-voltage regulators is a three-terminal regulator with an output current of up to 500 mA, no external components, internal thermal overload protection, high power dissipation capability, internal short-circuit current limiting, output transistor safe-area compensation, and is a direct replacement for the Fairchild µA78M00 series.

The AM15EW-IZ 15 Watt | DC-DC Converter is a switching power module produced by Aimtec. It features a wide 4:1 input range, adjustable output, low ripple and noise, operating temperature range of -40 to +75ºC, etc.

The document describes the features and characteristics of the Advanced Power P-CHANNEL ENHANCEMENT MODE Electronics Corp. POWER MOSFET, including simple drive requirement, voltage and current range, temperature characteristics, etc.

TFDU5307 is an infrared transceiver module produced by Vishay, which supports the latest IrDA physical layer standard, supports IrDA speeds up to 1.152Mbit/s (MIR) and carrier based remote control modes up to 2MHz

LMC-STC1D16/SSC1D16 is a 16 characters * 1 line, 1/16 duty 1/4 bias LCD display screen, TN/STN display mode, LED/EL backlight, 5 x 8 dot fonts, controller is NT3881 or equivalent, working voltage is DC+5V, LED backlight voltage is DC+5V, EL backlight voltage is AC90~100V(400~700HZ), EL inverter is I001A(I001B)

Features of the product:

The CXP819P60M is a CMOS 8-bit microcomputer which consists of A/D converter, serial interface, timer/counter, time base timer, vector interruption, high precision timing pattern generation circuit, PWM generator, PWM for tuner, 32kHz timer/event counter, remote control receiving circuit, general purpose prescaler, and external signal, as well as basic configurations like 8-bit CPU, PROM, RAM and I/O port. They are integrated into a single chip. Also the CXP819P60M provides sleep/stop function which enables to lower power consumption and ultra-low speed instruction mode in 32kHz operation. This IC is the PROM-incorporated version of the CXP81960M with built-in mask ROM. This provides the additional feature of being able to write directly into the program. Thus, it is most suitable for evaluation use during system development and for small-quantity production.

The document describes the features and characteristics of a general purpose rectifier diode 1N4004A, including glass sealed envelope, high reliability, and nonflammable.

This document describes the features and characteristics of the M24C16, M24C08, M24C04, M24C02, and M24C01 serial I²C bus EEPROMs, including a two-wire I2C serial interface supporting 400kHz protocol, single supply voltage range, write control input, byte and page write modes, random and sequential read modes, self-timed programming cycle, automatic address incrementing, enhanced ESD/latch-up behavior, over 1 million erase/write cycles, and over 40 years of data retention.