Industrial

The CP1500, 2500, 3500 series high current silicon bridge rectifiers have a plastic case with a heatsink, surge overload ratings up to 400 amps, and a 94V-O flammability rating.

ABB 5STP 33L2800 Phase Control Thyristor is designed for traction, energy and industrial applications, features patented floating silicon technology, low on-state and switching losses, optimum power handling capability and interdigitated amplifying gate.

This product is a 3-input AND gate with single event latch-up function, which can operate reliably in any radiation environment.

HS-2620RH and HS-2622RH are radiation hardened bipolar operational amplifiers that feature very high input impedance coupled with wideband AC performance.

CNC7S101, CNZ3182, CNC7T101, CNC1H101 are ON Semiconductor's optoisolators that support AC input, with high I/O isolation voltage, high current transfer ratio (CTR) and high response speed.

The 82C237 is a modified version of the 82C37A. It is fully software and pin for pin compatible with the 82C37A but provides an additional mode for 16-bit DMA transfers and enhanced speed. Each channel may be individually programmed for 8-bit or 16-bit data transfers. The 82C237 controller can improve system performance by allowing external devices to transfer data directly to or from system memory. Memory-to-memory transfer capability is also provided, along with a memory block initialization feature. DMA requests may be generated by either hardware or software, and each channel is independently programmable with a variety of features for flexible operation. The 82C237 is designed for use in high-end computer systems and offers high performance and low power consumption.

The document describes the features of the CENTRAL SEMICONDUCTOR CMDZ2L4 series silicon low level zener diode, including low operating current, low leakage, and a sharp knee.

M54/74HCT157/158 are high speed CMOS QUAD 2-CHANNEL MULTI- PLEXERs fabricated with silicon gate C2MOS technology. They achieve the high speed operation similar to equivalent LSTTL while maintaining the CMOS low power dissipation. These devices consist of four 2-input digital multiplexers with common select and strobe inputs. The HCT158 is an inverting multiplexer while the HCT157 is a non-inverting multiplexer. When the STROBE input is held High, selection of data is inhibited and all the outputs become Low in the M74HCT157 and High in theM74HCT158. The SELECT decoding determines whether the A or B inputs get routed to their corresponding Y outputs. All inputs are equipped with protection circuits against static discharge and transient excess voltage.

The data sheet introduces the features and characteristics of the Agilent HLMP-Pxxx series, HLMP-Qxxx series, HLMP-6xxx series, HLMP-70xx series, including subminiature flat top package, subminiature dome package, TTL and LSTTL compatible 5 volt resistor lamps, six colors, ideal for space limited applications, axial leads, with lead configurations for surface mounting and through hole PC board mounting

hlmp-4100/4101 t-13/4 (5mm) double heterojunction algaas very high intensity red led lamps data sheet

The ZXCL series are very small low dropout regulators designed for use in low power and severely space limited applications. The devices operate with a low dropout voltage, typically of only 85mV at 50mA load. Supply current is minimised with a ground pin current of only 50µA at full 150mA load. Logic control allows the devices to be shut down, consuming typically less than 10nA. These features make the device ideal for battery powered applications where power economy is critical.

This document describes the features and characteristics of the ST93C46 series 1K-bit serial EEPROM products, including 1 million erase/write cycles, 40 years data retention, dual organization, self-timed programming cycle, etc.

This is an English document about ZPD 1…ZPD 75 (0.5 W) silicon planar Zener diodes.

The document contains information about ZPD10 suppliers and describes the features and characteristics of the ZPD10 product.