Industrial

The PTF 10149 is an internally matched 70-watt GOLDMOS FET intended for cellular and GSM amplifier applications from 921 to 960 MHz. It operates with 50% efficiency and 16 dB typical gain. Nitride surface passivation and full gold metallization ensure excellent device lifetime and reliability.

The PRC202/212 is a thin film resistor-capacitor termination network from California Micro Devices Corp. It is designed to eliminate transmission line effects on high speed data lines. The network supports (terminates) 18 data lines and requires no DC power. The small surface mount packages improve board yields and reliability, minimize space and routing problems on the board, and reduce assembly costs. The PRC202/212 is a space efficient and cost effective replacement for conventional MLCC surface mount chip resistors and capacitors.

The PM-Hx22 series of current transducers can be used to monitor motors, pumps or other electrical loads where a linear voltage output signal is required. The output can be used to check operating status, failure, wear/strain and power for consumption analysis. The linear output signal is produced by the unit which is proportional to the current passing through the transducer.

The PHE13002AU is a high-voltage, high-speed planar-passivated npn power switching transistor in the SOT533 envelope intended for use in high frequency electronic lighting ballast applications, converters and inverters, etc.

The PEEL16V8 is a Programmable Electrically Erasable Logic (PEEL) device providing an attractive alternative to ordinary PLDs. The PEEL16V8 offers the performance, flexibility, ease-of-design and production practicality needed by logic designers today. The PEEL16V8 is available in 20-pin DIP and PLCC packages with speeds ranging from 15ns to 25ns and power consumption less than 45mA. EE-reprogrammability provides the convenience of instant reprogramming for development and a reusable production inventory minimizing the impact of programming changes or errors. EE-reprogrammability also improves factory testability, thus ensuring the highest quality possible. The PEEL16V8 architecture allows it to replace standard 20-pin PAL devices. ICT’s PEEL16V8 can be programmed with any existing 16V8 JEDEC file. Some programmers also allow the PEEL16V8 to be programmed directly from PAL 16L8, 16R4, 16R6 and 16R8 JEDEC files. Additional development and programming support for the PEEL16V8 is provided by popular third-party programmers and development software. ICT also offers free PLACE development software and a low-cost development system (PDS-3).

This document describes the features and characteristics of the PDTC123ET NPN resistor-equipped transistor, including built-in bias resistors, simplified circuit design, and reduction of components and board space. It is especially suitable for space reduction in interface and driver circuits, and inverter circuit configurations without the use of external resistors.

This document describes the features and characteristics of the PDF-5C series power dividers/combiners produced by MERRIMAC. The product features low insertion loss, broadband capability, and high reliability hermetic flatpack packaging.

Unanswerable

SpectrAlert wall-mount horn/strobe product is an outdoor listed strobe that operates on 120VAC. The horn/strobe is watertight when used in con- junction with the weatherproof back box (WBB).

The NTE5850 through NTE5869 are low power general purpose rectifier diodes in a DO4 type package designed for battery chargers, converters, power supplies, and machine tool controls.

NTC Thermistor sensor, with a negative temperature coefficient, measured in accordance with IEC 60539.

MSM80C154S/83C154S is a higher performance 8-bit microcontroller providing low-power consumption. MSM80C154S/83C154S covers the functions and operating range of the existing MSM80C154/83C154/80C51F/80C31F. MSM80C154S is identical to the MSM83C154S except it does not contain the internal program memory (ROM).