Philips manuals, page 96
PHILIPS BT131 series Triacs logic level Product data sheet
The document introduces a three-terminal triac with sensitive gate and passivation capability, which can be directly interfaced with microcontrollers, logic integrated circuits, and other low-power gate trigger circuits. It is mainly used for general purpose switching and phase control.
philips 74LVC2G04 Dual inverter handbook
This is a product specification sheet that describes the features and characteristics of the 74LVC2G04 dual inverter, including wide supply voltage range, 5V tolerant input/output, high noise immunity, compliance with JEDEC standards, ESD protection, low power consumption, etc.
philips 74HC/HCT563 Octal D-type transparent latch 3-state inverting handbook
The 74HC/HCT563 is a high-speed Si-gate CMOS device and is pin compatible with low power Schottky TTL (LSTTL). They are specified in compliance with JEDEC standard no. 7A. The 74HC/HCT563 are octal D-type transparent latches featuring separate D-type inputs for each latch and inverting 3-state outputs for bus oriented applications. A latch enable (LE) input and an output enable (OE) input are common to all latches.
PHILIPS PESDxL1BA series Product data sheet
This product data sheet introduces the PESDxL1BA series low capacitance bidirectional ESD protection diodes, which are packaged in a very small SOD323 (SC-76) SMD plastic package and designed to protect one signal line from damage caused by ESD and other transients.
PHILIPS PDIUSBD11 USB device with serial interface handbook
The document introduces the PDIUSBD11 USB device with a serial interface. It complies with the Universal Serial Bus specification Rev. 1.1, ACPI, OnNOW, and USB power management requirements. It is also compliant with USB Human Interface Devices and Monitor Control Class. The PDIUSBD11 integrates a Serial Interface Engine, FIFO memory, and transceivers, and has automatic USB protocol handling. It has a high-speed I2C interface (up to 1 Mbit/s) and is compatible with the PDIUSBH11 software. Additionally, it features a low-frequency 12 MHz crystal oscillator, programmable output clock frequency, bus powered capability with low suspend current, and a single 3.3 V supply with 5 V tolerant I/O. It is available in 16-pin DIP and SO packages.
PHILIPS PCF1179C 4-digit duplex LCD car clock handbook
PCF1179C is a 4-digit duplex LCD car clock produced by Philips Semiconductors.
PHILIPS 83C750/87C750 80C51 8-bit microcontroller family 1K/64 OTP ROM low pin count handbook
The 83C750/87C750 is a family of 80C51 architecture microcontrollers from Philips Semiconductors with 1K/64 OTP/ROM and low pin count. They are suitable for logic replacement, consumer and industrial applications.
PHILIPS P83Cx80; P87C380 Microcontrollers for monitors with DDC interface auto-sync detection sync proc. handbook
This is a monitor microcontroller product with DDC interface, auto-sync detection and sync processing function.
Philips Semiconductor NE/SE5410 handbook
The NE5410/SE5410 is a 10-bit high-speed multiplying digital-to-analog converter that is pin- and function-compatible with the industry-standard MC3410, but with improved performance. These converters have high-speed performance and are used as general-purpose building blocks in cost-effective D/A systems. The NE/SE5410 provides complete 10-bit accuracy and differential non-linearity over temperature, and a wide compliance voltage range. Segmented current sources, in conjunction with an R/2R DAC, provide the binary weighted currents. The output buffer amplifier and voltage reference have been omitted to allow greater speed, lower cost, and maximum user flexibility.
Philips Semiconductors SC16C2550 handbook
The SC16C2550 is a 2 channel Universal Asynchronous Receiver and Transmitter (UART) used for serial data communications. Its principal function is to convert parallel data into serial data and vice versa. The UART can handle serial data rates up to 5 Mbits/s. The SC16C2550 is pin compatible with the ST16C2550. It will power-up to be functionally equivalent to the 16C2450. The SC16C2550 provides enhanced UART functions with 16-byte FIFOs, modem control interface, DMA mode data transfer. The DMA mode data transfer is controlled by the FIFO trigger levels and the TXRDY and RXRDY signals. On-board status registers provide the user with error indications and operational status. System interrupts and modem control features may be tailored by software to meet specific user requirements. An internal loop-back capability allows on-board diagnostics. Independent programmable baud rate generators are provided to select transmit and receive baud rates. The SC16C2550 operates at 5 V, 3.3 V and 2.5 V and the Industrial temperature range, and is available in plastic PLCC44, LQFP48 and DIP40 packages.
PHILIPS P89C660/P89C662/P89C664/P89C668 80C51 8-bit Flash microcontroller family 16KB/32KB/64KB ISP/IAP FLASH with 512B/1KB/2KB/8KB RAM handbook
P89C660/P89C662/P89C664/P89C668 is an 80C51 8-bit Flash microcontroller family with 16KB/32KB/64KB ISP/IAP Flash and 512B/1KB/2KB/8KB RAM. It supports In-System Programming (ISP) and In-Application Programming (IAP), allowing for online downloading and remote programming. Additionally, it provides twice the speed of a conventional 80C51 in terms of instruction execution.
PHILIPS 83C748/87C748 80C51 8-bit microcontroller family 2K/64 OTP/ROM low pin count handbook
This document describes the features and characteristics of Philips 83C748/87C748 80C51 8-bit microcontroller family, including small package size, low cost, high-density CMOS technology, ROM and RAM capacity, timer, interrupt structure, etc.
PHILIPS BLT70 UHF power transistor Data Sheet
This product is a UHF power transistor of the BLT70 model produced by Philips company. It has a very high efficiency and low working voltage. It is suitable for hand-held radio equipment in the 900MHz communication band in common emitter class AB operation.
PHILIPS OM6206 65 × 102 pixels matrix LCD driver Data Sheet
This document is about the product specification of OM6206 65 × 102 pixels matrix LCD driver. It includes detailed information about the features, applications, general description, ordering information, pin functions, etc.
PHILIPS 87C654 handbook
The 87C654 is a single-chip 8-bit microcontroller manufactured by Philips Semiconductors. It is a derivative of the 80C51 microcontroller family and has been enhanced with additional features and capabilities. The 87C654 contains a 16k-byte EPROM, a 256-byte RAM, four 8-bit I/O ports, two 16-bit timers/counters, a multi-source, two-priority-level, nested interrupt structure, an I2C interface, a UART interface, and an on-chip oscillator and timing circuits. Additionally, the 87C654 can be expanded using standard TTL-compatible memories and logic.