Rockwell Automation MicroLogix 1400 Error 5H: Feedforward Bias (FF) is out-of-range

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code5H

Feedforward bias FF is out of the valid range (-6383 to +6383), causing an error. The manual's first action is: “Change FF so it is within the range -6383...+6383.”

Model
Rockwell Automation MicroLogix 1400
Display shows
Feedforward Bias (FF) is out-of-range (5H)
Type
Error code
Source
Manual p. 231

What 5H means

Feedforward Bias (FF) is out-of-range p. 231

Common causes

  • Feedforward Bias (FF) is out-of-range. p. 231

What to do

  1. Change FF so it is within the range -6383...+6383. p. 231

Before you service the product, read the safety instructions in the manual p. 274.

If 5H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 5H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.