Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
DE indicates move command data size for position control is too large. The manual's first action is: “PR”
DP indicates a CRC error occurred in data transmitted from the NC. The manual's first action is: “PR”
PMOC indicates a current higher than the specified value was supplied to the IPM in the main spindle drive circuit. The manual's first action is: “PR”
OS indicates the motor speed exceeded 115% of the maximum speed. The manual's first action is: “PR”
OSE indicates the speed command and motor speeds differed beyond the specified limit for a duration. The manual's first action is: “PR”
NS2 indicates no signal from the spindle encoder or the signal is not at its proper level. The manual's first action is: “PR”
ADE indicates the AD converter for current detection did not operate normally at initialization. The manual's first action is: “PR”
SWE indicates S/W data processing failed to finish within the specified time. The manual's first action is: “PR”
ME1 indicates a ROM or RAM check error occurred in the spindle drive control card. The manual's first action is: “PR”
Pwr sply EMG stop setting err means the rotary switch setting and parameter (PTYP) setting do not match. The manual's first action is: “AR”
POV indicates the voltage between L+ and L- exceeded 410V. The manual's first action is: “NR”
Pwr sply over regeneration means the power supply's regenerative capacity limit was exceeded. The manual's first action is: “AR (Note)”
PINL indicates an external contactor was turned OFF despite being ready ON, or a power failure of 55ms or more occurred. The manual's first action is: “NR”
PADE indicates an error was detected in the A/D converter section or power supply. The manual's first action is: “AR”
PME means an error occurred in the memory circuit section. The manual's first action is: “AR”