Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The axis selection on the 2-axis integrated drive unit is set incorrectly. The manual's first action is: “AR”
The PN bus voltage has dropped to 200V or below, indicating under-voltage conditions. The manual's first action is: “PR”
A parameter setting is incorrect, causing an initial parameter error. The manual's first action is: “Check the value.”
There is a fault in the circuit that detects the battery alarm condition. The manual's first action is: “Write down as much information as possible about the conditions in which the problem occurred, and contact the n…
The battery used to save data in the NC has dropped below acceptable voltage levels. The manual's first action is: “Replace the battery. Check the machining program after replacing the battery.”
The NC temperature has exceeded the specified range, indicating overheating. The manual's first action is: “Cooling measures are required. Turn OFF the NC power, or lower the temperature with an air conditioner, etc.”
The system received an invalid frame during communication with the amplifier. The manual's first action is: “Check whether there is any abnormality in the following : Cable (Are there any broken wires?), Cable shield …
Communication errors have occurred between the NC and amplifier, likely due to CRC checksum failures. The manual's first action is: “Check whether there is any abnormality in the following : Cable (Are there any broke…
An error occurred in communication with the amplifier due to incorrect axis number or type settings. The manual's first action is: “Check whether there is any abnormality in the following : Cable (Are there any broken…
The system received an invalid frame during communication with the amplifier. The manual's first action is: “Check whether there is any abnormality in the following : Cable (Are there any broken wires?), Cable shield …
A communication error has occurred between the NC and amplifier, likely due to cable or connector issues. The manual's first action is: “Check whether there is any abnormality in the following : Cable (Are there any b…
There is a communication error between the NC and amplifier due to improper setup or connection. The manual's first action is: “Check whether there is any abnormality in the following : Cable (Are there any broken wir…
An error occurred during the initial communication with the servo system. The manual's first action is: “Check the servo/spindle amplifier setting, connection, axis No. in the spindle specification parameters, "No amp…
A watch dog error has occurred, indicating an abnormal system condition. The manual's first action is: “Write down as much information as possible about the conditions in which the problem occurred, and contact the ne…
The ladder process stopped abnormally due to a software exceptional interrupt. The manual's first action is: “Write down as much information as possible about the conditions in which the problem occurred, and contact …