Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
An axis command that cannot be divided by the command unit was issued. The manual's first action is: “Reconsider the program.”
The axis address commanded by the program and the axis address set by the parameter do not match. The manual's first action is: “Revise the axis names in the program.”
The number of axis addresses commanded in the same block exceeds the specifications. The manual's first action is: “Divide the alarm block command into two. Check the specifications.”
The designated sequence No. (or program No.) does not exist, or a block having the designated block No. does not exist. The manual's first action is: “Reconsider the program.”
The designated program file does not exist. The manual's first action is: “Reconsider the program.”
A program file has not been designated. The manual's first action is: “Reconsider the program.”
A nonexistent or inoperable device was designated. The manual's first action is: “Check the device availability and whether it is usable.”
A search was attempted during program operation. The manual's first action is: “Execute the search after the program operation has finished.”
Automatic start was attempted in a mode different from that of the device for which operation search was performed. The manual's first action is: “Match the operation mode with that of the searched device, then retry …
The program was restarted from the head. The manual's first action is: “To restart the operation from the program head, press cycle start.”
An NB number not available was designated for the search. The manual's first action is: “Check the NB number.”
The block immediately after the NURBS interpolation mode was designated as the restart position, and the program was restarted. The manual's first action is: “Designate a block other than the block immediately after t…
An operation not provided in the specifications was attempted. The manual's first action is: “Check the specifications.”
A program operation, restart search, or machining time calculation was attempted during a program check, which conflicts with current state and must be delayed until completion. The manual's first action is: “Carry ou…
Program checks or similar actions were attempted while the machine was actively operating, which is not permitted during runtime. The manual's first action is: “Carry out program checks after finishing the operation.”