Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
PCH E occurs when the main circuit condenser is not correctly charged. The manual's first action is: “PR”
Pwr sply rush relay fusion indicates that the rush resistance short-circuit relay is still ON. The manual's first action is: “PR”
Pwr sply ext contactor fusion means the external contactor was turned ON despite the READY OFF status. The manual's first action is: “PR”
PPNG indicates a ground fault was detected in the motor, only during ready ON mode. The manual's first action is: “PR”
PWD occurs when the power supply software processing fails to finish within the specified time. The manual's first action is: “AR”
PPHL means the input power (R, S, T) has an open phase. The manual's first action is: “PR”
PRAE indicates that the rush resistance short-circuit relay is not ON. The manual's first action is: “PR”
PARE occurs when the auxiliary regeneration transistor remains ON. The manual's first action is: “PR”
POC is triggered when an overcurrent (Ic) is detected in the power module (IPM). The manual's first action is: “PR”
MCE means the external contactor contact was fused. The manual lists no action for this code.
CLT3 indicates that the collision detection method 2 error was detected. The manual's first action is: “NR”
CLT2 occurs during G1 modal (cutting feed) when collision detection method 1 error is detected. The manual's first action is: “NR”
CLT1 is triggered during G0 modal (rapid traverse) when collision detection method 1 error is detected. The manual's first action is: “NR”
EM indicates that after an external emergency stop was input, the contactor cutoff command was not issued even after 30 seconds passed. The manual's first action is: “NR”
Excessive error3 happens when, upon turning the servo OFF, the actual position exceeds the excessive error width 3 value (parameter OD3). The manual lists no action for this code.