Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
PRAE indicates the rush resistance short-circuit relay is not ON. The manual's first action is: “PR”
PARE means the auxiliary regeneration transistor remained ON. The manual's first action is: “PR”
POC indicates an overcurrent (Ic) was detected in the power module (IPM). The manual's first action is: “PR”
ORFE means pulse miss value exceeded parameter setting (SP0114 OPER) after orientation in-position completion. The manual's first action is: “NR”
OD occurs when position tracking error exceeds the specified value during position loop operation. The manual's first action is: “NR”
OL signifies that the motor current exceeded the overload detection level for too long, surpassing the allowed time constant. The manual's first action is: “NR”
OHM means the motor overheated due to overload or cooling blower failure triggering the thermal protector. The manual's first action is: “NR”
CAXE indicates that C-axis control was applied to the H coil while using the coil changeover motor. The manual's first action is: “NR”
KE2 indicates communication with the TK unit could not be performed correctly while it was in use. The manual's first action is: “PR”
KE1 indicates incorrect signal changeover procedure while using the TK unit. The manual's first action is: “PR”
PMOH indicates overheating was detected in the IPM of the spindle drive's main circuit. The manual's first action is: “PR”
TP2 indicates a protocol error occurred during communication with the NC (Information error). The manual's first action is: “PR”
TP1 indicates a protocol error occurred during communication with the NC (Frame error). The manual's first action is: “PR”
PE indicates a parameter value exceeded its tolerable range. The manual's first action is: “PR”
TE indicates periodic data transmission from the NC was interrupted. The manual's first action is: “PR”