Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The servo or spindle amplifier is not properly connected or its axis number setting is incorrect, preventing communication with the control system. The manual's first action is: “PR”
The spindle amplifier software failed to process commands within the required time frame, indicating a processing delay or error. The manual's first action is: “AR”
The power module (IPM) has overheated due to excessive heat detected during operation. The manual's first action is: “PR”
Pwr sply EMG stop setting err means rotary switch setting and parameter (PTYP) setting do not match. The manual's first action is: “AR”
POV indicates voltage between L+ and L– exceeded 410V. The manual's first action is: “NR”
Pwr sply over regeneration means regenerative capacity limit of the power supply was exceeded. The manual's first action is: “PR (Note)”
PINL indicates external contactor was turned OFF despite ready ON status, or instantaneous power failure of 55ms or more occurred. The manual's first action is: “NR”
PADE means an error was detected in the A/D converter section or power supply. The manual's first action is: “AR”
PME means an error occurred in the memory circuit section. The manual's first action is: “AR”
PCH E indicates the main circuit condenser is not correctly charged. The manual's first action is: “PR”
Pwr sply rush relay fusion det means the rush resistance short-circuit relay is still ON. The manual's first action is: “PR”
Pwr sply ext contct fusion det means the external contactor was turned ON despite READY OFF status. The manual's first action is: “PR”
PPNG indicates a ground fault was detected in the motor only during ready ON state. The manual's first action is: “PR”
PWD means the power supply software processing failed to finish within the specified time. The manual's first action is: “AR”
PPHL means an open phase exists in the input power (R, S, T). The manual's first action is: “PR”