Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The G60 command was used without uni-direction positioning specifications, which are required. The manual's first action is: “Check the specifications. Change the G60 program command to G00.”
The commanded movement distance exceeds the maximum allowable limit (2^31). The manual's first action is: “Reconsider the program.”
A G code was issued for inch/mm conversion without any such specification being set. The manual's first action is: “Check the specifications.”
The end point coordinate command is missing for an R-designated arc. The manual's first action is: “Reconsider the program.”
An H code other than H0 was used independently during tool length offset. The manual's first action is: “Reconsider the program.”
Multiple G codes were issued within the same group in the program. The manual's first action is: “Reconsider the program.”
Too many addresses were commanded simultaneously in one block, exceeding the allowed limit. The manual's first action is: “Reconsider the program.”
The program block lacks an EOB code when an EOR (%) code was used. The manual's first action is: “Use an EOB code at the end of the program block.”
"n" has been issued even though there are no optional block skip addition specifications. The manual's first action is: “Check the specifications.”
Zero has been designated for a program number or sequence number. The manual's first action is: “The program numbers are designated across a range from 1 to 9999999. The sequence numbers are designated across a range …
"EOR" has been read during tape and memory operation. M02 and M30 are not entered at the end of the program. M99 is not entered at the end of the subprogram. (Or, G23 or G68 is not entered at the end. The manual's fir…
The setting range for the addresses has been exceeded. The manual's first action is: “Reconsider the program.”
A G code not listed in the specifications has been used. The manual's first action is: “Check and correct the G code address in the program.”
The command format in the program is not correct. The manual's first action is: “Reconsider the program.”
An address not listed in the specifications has been designated. The manual's first action is: “Check and revise the program address. Check the specifications.”